Jump to content
AlDente67

Important - Need HVAC replacement now - Anybody?

Recommended Posts

My AC crapped out yesterday.  It was old - 1999 or so.  Cost to repair is huge.  Cost to replace is huger (is that a word?)  May as well get it done instead of duct tape repairs that will fail anyway.

 

What sort of quotes would be reasonable for a single-zone A/C and gas Heat furnace (both are struggling)?  Nothing top line fancy, but something to invest in for the next 15 years?

 

My service guy thinks $12k is in the ballpark for a 14 SEER Ac and 2-stage blower.  No electrical or special ducting needed.

 

Anyone?

 

Are there any decent incentives around these days?

Share this post


Link to post
Share on other sites

Check with your gas or electricity company for rebates. PSE&G has a page of them.

 

I had my coil and Condenser done about 3 years ago. 4K for 3.5 ton. I'd guess another 5-6k for a 120kbtu furnace.

 

Edit. I have york. Trane Lennox carrier may be more.

 

 

Sent from my iPhone using Tapatalk

Share this post


Link to post
Share on other sites

Check with your gas or electricity company for rebates. PSE&G has a page of them.

 

I had my coil and Condenser done about 3 years ago. 4K for 3.5 ton. I'd guess another 5-6k for a 120kbtu furnace.

 

Edit. I have york. Trane Lennox carrier may be more.

 

 

Sent from my iPhone using Tapatalk

 

Thanks fish.  I spoke to a few...they suggest a 5 ton AC unit for 2400 sq ft of space.  Seems high?

Share this post


Link to post
Share on other sites

All depends on the house and build. Ask them to show you the heat loss calculations. You are better with a right size unit that runs longer than an oversized unit that short cycles.

 

I have a 2200 ft ranch with standard 2x4 construction.

 

 

Sent from my iPhone using Tapatalk

Share this post


Link to post
Share on other sites

Thanks fish. I spoke to a few...they suggest a 5 ton AC unit for 2400 sq ft of space. Seems high?

1 ton per every 500sq foot of living space is about what the heat loss calculator or manual J will work out to be. So 5 ton is about right. I just did a 5 ton Ac condenser, case coil, 13 seer single stage, 120K btuh furnace Comfort maker (which is owned by Carrier corp) replacement. Think with everything including transition ductwork, and new lineset I did the entire job for $8500...

Share this post


Link to post
Share on other sites

Is it true now that a dual zone system is run off of one condenser now? Does that one condenser cost way more than a standard single unit?

As soon as you start going higher than 14 seer on a condenser the price starts jumping in about $2000 dollar increments. Considering we don't live in Florida, and only use our AC units for about 3 month of the year solid, it doesn't usually pay to step up to 16.5 seer over the lifetime of the unit. Most new equipment lasts about 12 years before failure, if you get 15 you didn't good. Buy that time you just recoupe the extra you spent to jump up in efficiency maybe.

 

 

You can zone any ducted system with zone control dampers. But it's a poor practice to use. For true efficient zoning, multiple ducted systems or mini splits are ideal. I can do 5 mini split heads off of one condenser. That's 5 separate zones. I can go to 8 heads with branch boxes, off of one condenser as well.

Share this post


Link to post
Share on other sites

Energy rebates in NJ are administered by the Office of Clean Energy.

 

Everything you need is here http://www.njcleanenergy.com

There are usually state and federal rebates every year, depending on if their energy standards are met by the new equipment.

 

Here are this year's standards. The new standards are probably in the mail to me now.

 

4bd3e8963056414ae6a65eef7f245322.jpg

Share this post


Link to post
Share on other sites

Ended up with a system from the outfit who does my spring checkups.  Wasn't cheap but I can already feel the difference over the old one.  A Lennox setup.  Thought the incentives were more substantial, but it was something.

They said if we could start the next day, the owner would throw in a free humidifier.  As we are sitting there sweating, we said to go ahead.

 

I'm sure I could have shaved a few bucks with shopping around for a few days, but everyone in this house becomes a wreck if we can't sleep in cold rooms.

 

The techs said that the layout they had to work with was a challenge.  They custom fabbed a fair bit around the plenum to get a good fit.

 

For some reason, I thought the incentives were in the thousands back in 2000 when I had the last system put in, but I could be foggy on that.

 

The funny part is that the standard 3-day right of recision applies since it was an in-home sales consult and contract.  That would make it 7pm tonight to cancel the contract, and then lock the doors so they can't come in and rip it out.  :)

  • Like 1

Share this post


Link to post
Share on other sites

Ended up with a system from the outfit who does my spring checkups.  Wasn't cheap but I can already feel the difference over the old one.  A Lennox setup.  Thought the incentives were more substantial, but it was something.

They said if we could start the next day, the owner would throw in a free humidifier.  As we are sitting there sweating, we said to go ahead.

 

I'm sure I could have shaved a few bucks with shopping around for a few days, but everyone in this house becomes a wreck if we can't sleep in cold rooms.

 

The techs said that the layout they had to work with was a challenge.  They custom fabbed a fair bit around the plenum to get a good fit.

 

For some reason, I thought the incentives were in the thousands back in 2000 when I had the last system put in, but I could be foggy on that.

 

The funny part is that the standard 3-day right of recision applies since it was an in-home sales consult and contract.  That would make it 7pm tonight to cancel the contract, and then lock the doors so they can't come in and rip it out.   :)

Glad you are back up.  The incentives were HUGE after the economy tanked, I think I got a Federal credit of $4,000 on one system and the HVAC company gave another $1,000 and the state through in $1,500.  But that was then and this is now.  At the time I replaced a 30 year old system just because it was only and the deal was so good.  So, I guess the incentive worked to help the economy as they motivated me to save $6,500 on something that I likely would have done anyway in a year or two. :)

Share this post


Link to post
Share on other sites

Ended up with a system from the outfit who does my spring checkups. Wasn't cheap but I can already feel the difference over the old one. A Lennox setup. Thought the incentives were more substantial, but it was something.

They said if we could start the next day, the owner would throw in a free humidifier. As we are sitting there sweating, we said to go ahead.

 

I'm sure I could have shaved a few bucks with shopping around for a few days, but everyone in this house becomes a wreck if we can't sleep in cold rooms.

 

The techs said that the layout they had to work with was a challenge. They custom fabbed a fair bit around the plenum to get a good fit.

 

For some reason, I thought the incentives were in the thousands back in 2000 when I had the last system put in, but I could be foggy on that.

 

The funny part is that the standard 3-day right of recision applies since it was an in-home sales consult and contract. That would make it 7pm tonight to cancel the contract, and then lock the doors so they can't come in and rip it out. :)

Once they install anything they can't rip it out. It's part of the house once it's in place. All material on the job site is property of the contractor until it's installed. But if you agree to the contract and the start date you agree to is before the 3 day back out period. You're SOL lol... Besides it's pretty easy to lean the property for the amount owed.

 

Lennox makes decent equipment. You should be happy with their stuff.

 

The incentives change every year, for both state and federal rebates.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.



  • olight.jpg

    Use Promo Code "NJGF10" for 10% Off Regular Items

  • Supporting Vendors

  • Latest Topics

  • Posts

    • Boom! Today all Newton is in the high $3.60s. All hail Bidenomics! And all that Alaska land he just took off the list of oil prospects.
    • I have a like new (only zeroed) PSA Sabre KAC M110 Clone in 7.62x51mm. This is PSA's clone version of the infamous Knights Armament M110. Very high quality, excellent 2 stage trigger, 20" chrome lined barrel, adjustable gas block, and is NJ legal with a pinned Surefire SOCOM muzzle brake.  Radian Raptor charging handle and Radian ambi safety. Upper and lower are billet receivers compatible with all KAC SR-25 and LMT MWS/MARS-H pattern receivers.  Im no where close to being a long range shooter but ive been able to get 0.7 MOA out of it with 175gr federal gold medal match ammo and Im sure the rifle is capable of much better accuracy. Asking $1650 (which is a steal for what you get) at any FFL thats a reasonable distance from Jersey City. I can also ship but that would be on your dime.  Optic/bipod etc not included but can be purchased if interested. Vortex Razor Gen-II HD 3-18x50 FFP with the new EBR-7C MRAD illuminated reticle in a 1.54 reptilia mount. Id include the optic for another $1700. Happy to answer any questions or provide more pictures. Not interested in any trades. Thank you.
    • Selling 1 sealed spam can Romanian 7.62x54r ammo containing 440 rounds. 1982 manufacture.  Steel core light ball, copper washed steel case.  Not reloadable.  Corrosive primer. The rust you see on the top is light surface rust. Can is intact.  Comes with opener. $285.00 cash.  I live in NW Burlington County, and work in Trenton.  I can meet you at a reasonable distance to make sale.   The first to reply “I’ll take it” wins the sale. 
    • Still want to put your dog in kennel? https://newjersey.news12.com/police-crews-rescue-46-dogs-from-fire-inside-pio-costa-industrial-complex-in-fairfield
×
×
  • Create New...