Search the Community
Showing results for tags 'recall'.
Found 3 results
Guys and gals, FYI... Winchester just issued a recall for 38 Special 130 Grain FMJ ammo. Notice below. PRODUCT WARNING AND RECALL NOTICE WINCHESTER® 38 Special 130 Grain Full Metal Jacket Olin Winchester, LLC (“Winchester”) is recalling three (3) lots of 38 Special 130 Grain Full Metal Jacket centerfire ammunition. Symbol: USA38SPVP Lot Numbers: KF21, KL30 and KM52 Winchester has determined the above lots of 38 Special ammunition may contain incorrect powder charges. Ammunition with excessive powder charges may cause firearm damage, rendering it inoperable, and subjecting the shooter and bystanders to a risk of serious personal injury or death. DO NOT USE WINCHESTER® 38 SPECIAL 130 GRAIN SYMBOL USA38SPVP WITH LOT NUMBERS KF21, KL30 or KM52. The ammunition Lot Number is ink stamped inside the right tuck flap of the 100-round carton as indicated here. The symbol is printed above the UPC bar code. To determine if your ammunition is subject to this notice, review the Symbol and Lot Number. If it is Symbol USA38SPVP with Lot Number KF21, KL30 or KM52, immediately discontinue use and contact Winchester toll-free at 844-653-8358 for free UPS pick-up of the recalled ammunition. This notice applies only to Symbol USA38SPVP with Lot Numbers KF21, KL30 and KM52. Other Symbol or Lot Numbers are not subject to this recall. If you have any questions concerning this 38 Special centerfire ammunition recall please call toll-free 844-653-8358, write to Winchester (600 Powder Mill Road, East Alton, IL 62024 Attn: USA38SPVP Recall), or visit our website at www.winchester.com. For more information contact firstname.lastname@example.org
https://ruger.com/dataProcess/markIVRecall/index.php?r=y Ruger recently discovered that all Mark IV[emoji769] pistols (including 22/45[emoji769] models) manufactured prior to June 1, 2017 have the potential to discharge unintentionally if the safety is not utilized correctly. In particular, if the trigger is pulled while the safety lever is midway between the "safe" and "fire" positions (that is, the safety is not fully engaged or fully disengaged), then the pistol may not fire when the trigger is pulled. However, if the trigger is released and the safety lever is then moved from the mid position to the "fire" position, the pistol may fire at that time. Sent from my SM-T350 using Tapatalk
OFFICIAL NOTICE Daniel Defense has issued a recall alert for certain firearms manufactured between April 1, 2016, and March 3, 2017. According to the popular AR manufacturer, in a few cases, an issue with the Disconnector in the Fire Control Group resulted in double fire condition with a single pull of the trigger. To see if your firearm is affected by the recall, visit this page and follow the instructions. DD has said that it will “correct any and all potential conditions at no cost to the consumer as part of our 100% Satisfaction Guarantee.” For additional information, you can watch the video below. However, it is highly recommended that if you are at all concerned about your firearm, you check out that page with the recall instructions immediately.