Jump to content
Ahmrham

WTS Valkyrie long-range AR .224 rifle

Recommended Posts

WTS  Valkyrie .224 rifle , a near-virgin weapon  

 Located in Monmouth county 

1.  Stainless steel barrel, 18” 1::7 twist
2.    15” Carbon fiber handguard 
3.    Adjustable gas block, steel, clamp-on
4.    Vortex Scope, 2.5-10 x44
5.    American Defense QD cantilever scope mount
6.    Drop-in cassette, high-end Fire Control Group, flat-face trigger, pull = 3.5 lbs
7.    POF lower receiver Cerkoted
8.    Geissele Automatics Maritime Extended Bolt Catch
9.    Steel (not the usual aluminum) charging handle
10.    Nickel boron bolt carrier
11.    ASC aluminum magazine, ten-round (not pictured)
12.    Griffin Armament M4SD Compensator/Brake muzzle device
13.    Griffin Armament CQB Gen 2 Blast Shield 
14.    Engraved dust cover/ejection door  “.224 Valkyrie”
15.    Harris Engineering Bipod HB25,  12”-25" legs
16.    Harris Engineering MLRA M-Lok QD rotating adapter

 •    Additional photos available on request
•    2000 USD  
•    The first to post "I'll take it" wins the sale.

  • The UR is a standard forged one ... there's only about three makers of forged upper receivers and they are all the same specs. I can't remember where I got this particular one.
    It's not cerakoted. 
  • The stainless-steel barrel is a PSA 18" 1::7
  • The drop in cassette FCG is a CMC single stage  w/ flat-face trigger.
  • The  Griffin Armament muzzle device is permanently attached via the old "pin and weld" method
    ValkMuzz.jpgValkHarris.gif.75f1b786c955f33a176f38537dbfd3c9.gif

Share this post


Link to post
Share on other sites
9 hours ago, Heavyopp said:

Did you assemble this?

Deleted—

Yes, I built it.

  • The UR is a standard forged one ... there's only about three makers of forged upper receivers and they are all the same specs. I can't remember where I got this particular one. It's not cerakoted. 
  • The stainless-steel barrel is a PSA 18" 1::7
  • The drop in cassette FCG is a CMC  single stage  flat-face.
  • The muzzle device is permanently attached via the old "pin and weld" method

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.



×
×
  • Create New...