82flh 16 Posted August 31, 2021 im a welder fabricator by trade i cant imagine this not being permanent would this be legal if i do it myself drill thru whole mag with a solid piece of bar...weld each end of mag? this is a side view obviously 1 Quote Share this post Link to post Share on other sites
Krdshrk 3,877 Posted August 31, 2021 The issue is that you would be in possession of a mag capable of holding more than 10 rounds before you actually do this... Quote Share this post Link to post Share on other sites
82flh 16 Posted August 31, 2021 krd.....im still out of state bro im preparing 1 Quote Share this post Link to post Share on other sites
82flh 16 Posted August 31, 2021 what would be a good material to use as the pin going thru? i guess any steel rod? all mags are all steel except 10....my others are pmags not sure about them...might just sell them Quote Share this post Link to post Share on other sites
Mr.Stu 1,916 Posted August 31, 2021 31 minutes ago, 82flh said: what would be a good material to use as the pin going thru? i guess any steel rod? all mags are all steel except 10....my others are pmags not sure about them...might just sell them Welding steel to steel is far easier than welding anything else to steel, right? I guess you could braze or silver solder something else. Hopefully you have a TiG or something as mag bodies tend to be pretty thin gauge steel. They still haven't delivered the wood welder I ordered from Etsy The issue I see with you proposal is the bar is going to interfere with the mag spring. You would be better off installing a vertical block/bar that fits inside the spring and limits how far down the mag the follower can go. Quote Share this post Link to post Share on other sites
82flh 16 Posted August 31, 2021 how about this for pmags? this video is california but would this fly in NJ Quote Share this post Link to post Share on other sites
Mr.Stu 1,916 Posted August 31, 2021 8 minutes ago, 82flh said: how about this for pmags? this video is california but would this fly in NJ Good to go. Quote Share this post Link to post Share on other sites
Displaced Texan 11,731 Posted August 31, 2021 I can’t wait to ‘un-ban’ my PMags when I leave this hellhole Quote Share this post Link to post Share on other sites
82flh 16 Posted September 1, 2021 anybody done the pin and weld with a mig? maybe if i turn the heat way up wont leave a big puddle Quote Share this post Link to post Share on other sites