Jump to content
Dooly

Recommended Posts

Dooly    41

Dooly
Posted

*SOLD*

 

A few basics:

  • LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
  • UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
  • BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 Twist, 16" Government Profile, Mid-length Gas System, Chrome Lined, Mil-Spec Heavy Phosphate Coated, and HP/MPI Tested
  • GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Mid-length, Direct Impingement
  • HANDGUARD: Daniel Defense MFR 15.0, CNC Machined of 6061-T6 Aluminum, M-LOK Attachment, Type III Hard Coat Anodized
  • RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum
  • BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding
  • PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch Overmolding
  • Ambi Safety.  Mil-Spec CH.
  • Made in the USA!

Must have matching DL and FID.  All required docs and fees by your FFL are on you.  I am in Bergen County.  If local to Bergen County (or relatively close), I can drop off the item in the original DD plastic case to the agreed upon FFL.   Thanks.

sgdasdga.jpg

asdfasdfasd.jpg

djgfjdgf.jpg

asdfasdfads.jpg

fjfgjdfg.jpg

  • Like 3

Share this post

Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Go To Topic Listing

  • Recently Browsing   0 members

    No registered users viewing this page.



×
×
  • Create New...