CMJeepster 2,777 Posted July 12, 2022 I've not owned a black oxide coated steel blade before, so I don't know how to safely remove the packaging tape residue that has built up on it. Any advice would be greatly appreciated. TIA! Quote Share this post Link to post Share on other sites
raz-0 1,259 Posted July 12, 2022 21 minutes ago, CMJeepster said: I've not owned a black oxide coated steel blade before, so I don't know how to safely remove the packaging tape residue that has built up on it. Any advice would be greatly appreciated. TIA! Whatever it is it should be fairly resistant to most cleaners. Start gentle with soap and water then relube. You can also just jump to any oil and see if that does it. 1 Quote Share this post Link to post Share on other sites
JohnnyB 4,322 Posted July 12, 2022 Goo Gone or Goof Off will work. 1 1 Quote Share this post Link to post Share on other sites
siderman 1,137 Posted July 12, 2022 Use that old bottle of Hoppe's 9 laying around. 1 Quote Share this post Link to post Share on other sites
CMJeepster 2,777 Posted July 12, 2022 Thanks, folks! I will start with dish soap and go from there. Quote Share this post Link to post Share on other sites
RichP 115 Posted July 12, 2022 pam or any cooking oil works, and WD-40 works 1 Quote Share this post Link to post Share on other sites
CMJeepster 2,777 Posted July 13, 2022 Hot water, dish soap and patience paid off. Got the sticky icky off and put a new edge on it. Quote Share this post Link to post Share on other sites