Jump to content
gunguynj

.223 for bolt action: affordable and accurate?

Recommended Posts

I am curious on the opinions of the board on the following matter:

 

I recently purchased a used .223 Tikka T3 TAC and it is my first rifle. It has a Buckmaster 6-18x40 scope and I primarily kill paper targets between 100-300 yards. I shoot from a bi-pod and a table in seated.

 

1) All I have shot is PMC bronze 55gr and Remington UMC. I cant tell if its me or does the shot miss the target most of the time? I didnt get many groupings

 

2) Is there any affordable and accurate ammunition that one could but factory loaded and be able to shoot say 100 rounds a week?

 

3) Does one have to hand load for this kind of accuracy

 

4) What ammo would you recommend if buying factory for tight, consistent, satisfying groups?

 

Thank you ahead of time and I apologize for not finding the relevant answer by searching.

Share this post


Link to post
Share on other sites

Take baby steps. Forget the bipod for the moment and shoot off of sand bags, a rolled up coat ,towels or a blanket. Get that rifle rock steady. Start at 50yd adjust your paralex for 50. Go out to 100 adjust paralex for 100.

 

Shoot your groups. If that rifle doesn't shoot 1" at 100yds with factory ammo something is wrong.

 

Shoot 3-5 rounds rest 5 minutes.

 

Report back with results.

Share this post


Link to post
Share on other sites

What Frank told you is good advice. In order to optimize your chances though, you have to make sure the ammunition is suitable for the gun. Rifles chamberd in .223 have various twist rates. Time was that 1:12 was the most common for a B/A .223 rifle, as they were primarily used to hunt varmints using light weight bullets. With the explosion of the "modern sporting rifle" market (read that: AR), the most common ammunition we see is 55 grains and up. A 1:12 twist rate may not suitably stabilize a 55 grain or heavier bullet. If the ammo you are using falls into that category, you are better off with a 1:7, 1:8 or 1:9 barrel. (And before somebody jumps on me, I know that it's bearing surface, not necessarily weight that determines what twist rate is best - as a rule of thumb, heavier bullets have longer bearing surfaces and require faster twist rates).

 

Next check your optics. Are all the mounts secure? All screws adequately and evenly torqued? Have you done a test at closer range to see if the scope is holding zero? Have you "shot the box"?

 

As for ammo, good target ammo doesn't come cheap. If you want accuracy and volume on a budget, then handloading is your only recourse. In order to sort your gun out though, you should go find some Federal Gold Medal Match - 69 gr BTHP (providing you have the proper twist rate (see paragraph 1). It can be found ranging in price from appx $17/20 up to $27/20. Gun shows are your best bet for finding it at the lower end of that price range.

 

Good luck.

 

Adios,

 

Pizza Bob

Share this post


Link to post
Share on other sites

Bob - He should be able to stabilize 55gr w/ almost any twist. Commercial plinking ammo should shoot an 1"-1 1/2" out of that rifle.

 

http://www.6mmbr.com/223rem.html

 

What you think?

 

Depends on the gun, and the shooter. I was just trying to give him things to tweak to optimize his chances

Share this post


Link to post
Share on other sites

The twist is 1/8 I believe. But Bob, your advice is not lost. I will do exactly that this Sunday or Monday at CR when i get there. I suppose I just dont enjoy the disappointing feeling of aiming for the bullseye and then seeing it hit 1" to the right when I KNOW I was dead on! I guess I never counted on the ammo being the wildcard!

Share this post


Link to post
Share on other sites

Well I was able to actually get some time in today and with the assistance of some ricebags I was able to pretty much zero in at 50 and 100 yards. Nice tight groupings and fairly accurate. It was really open on the range today so sunday afternoons are the time to go for sure. Its a good thing since I have to work tomorrow since my coverage called out.

 

I even used the bags on the pistol range to check the accuracy of my s&w model 60 357. That was certainly case of operator error as without it im low and left or high and right, and with it i got a sweet bullseye at 10 yards.

 

Very impressed with Cherry Ridge so far. Nice people. Just as long as I dont have to sit through another indoctrination meeting im good :-)

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.



  • olight.jpg

    Use Promo Code "NJGF10" for 10% Off Regular Items

  • Supporting Vendors

  • Latest Topics

  • Similar Content

    • By Dooly
      Selling a Trijicon ACOG - 3.5x35mm with a RED Chevron BAC Reticle + Mount.   TA11F.    THIS IS POWERED BY TRITIUM + FIBER OPTIC.  NOT BATTERY POWERED.
      The item was purchased NEW last month.  NEVER shot.

      $900 Shipped.  

      I accept discreet PP (F&F), Venmo, cash.  I'm located in Bergen County.  First to post "I'll take it" wins the sale.
          
    • By Dooly
      Item has been sold.  Please close thread.
       
       
       
       
       
       
    • By Dooly
      Purchased it Brand New from a store last month! (1 month old and in original box).    It has NEVER been loaded and fired!  (...at least never outside the factory that I know of assuming since I bought it brand new).  Everything on it is factory.  The factory includes only 1 magazine but I have an extra that I can include.  2 magazines total.  This model appears to be out-of-stock everywhere now. 
      Asking $1300 - Buyer is responsible for all fees required by the FFL for the transfer.  FID + matching DL ID required.   
      I'm located in Bergen County and can meet at any preferred FFL of your choice within reasonable distance in or very near to Bergen County.  Cash, Bank's cashiers check is preferred (check obviously must be cleared first) or USPS MO's.   
      The first to post "I'll take it" wins the sale.
      $1300
      TROY’s A4 - .223/5.56mm “other firearm” meets NJ legal compliance with a pinned flash hider and features the SBA3 5-position adjustable brace,TROY SOCC M-LOK BattleRail, TROY Poly CQB FVG – Mandatory and TROY Control Pistol Grip, pinned and welded TROY Medieval® Flash Suppressor.  Included are 2 magazines (10/30 magazines).
      Description
      Firearm Type: “Other Firearm” Semi Automatic
      Total Overall Length: 26.5″
      Receiver: 7075 Forged Aluminum Upper and Lower
      Barrel: 10.5 Chrome Molly – 1/7 Twist Rate
      Flash Hider: pinned Troy Medieval
      Operating System: Gas Impingement
      Gas System: Carbine Length – .750 Low-Pro Gas Block
      Hand Guard: TROY SOCC M-LOK BattleRail – 10.5″
      Front Grip: TROY Poly CQB FVG – Mandatory
      Stabilizing Brace: SB Tactical – Not Pinned
      Grip: TROY Control Grip
      Bolt Carrier: Standard
      Charging Handle: Standard
      Small Parts: Mil-Spec
      Magazine: 10rd (NJ) (Included 2 magazines)


    • By Sasahara
      Looking to sell 200 rounds of same lot 69gr .223 Federal Gold Medal Match (FGMM).  Would like a local sale but willing to drive a little.  Located in Bergen County.  Bought pre-shortage and just looking to get my money back since I haven't been to the range in a bit.  Asking $200 cash FTF.  The first to post "I'll take it" wins the sale.


    • By Bsels
      Selling 440rds of wolf steel 55gr .223, boxes of 20. $220 for the whole lot, not looking to sell individually. 
      6x 5ct boxes of 2 3/4” 12Ga frangible slugs $5 per box (pending sale)
      local pickup with cash in Lincoln Park NJ
      I’m new here but an active member on reddit r/njguns in case you want to check that I’m a real person in NJ, same username. 
      first to comment “i’ll take it” wins the sale



  • Posts

×
×
  • Create New...