thelosticon 0 Posted March 16, 2015 Not all that new, but the gen 2 has been out for a while now and it has had some pretty positive reviews on various forums and YouTube so I decided I would give it a try with my coupling method. In the past I have used a jb mix with an epoxy grit layer on top of all three ribs, that method was kinda permanent and you couldn't disassemble the mags for maintenance. So I did away with the jb and use this 3m industrial rubberized grit tape, pretty awesome stuff. Under the middle rib tape are located the 8 spring rolls that hold the internal coupler in place and bond the 2 15rd cut downs. The overall length is about 1/2 inch bigger than a standard 30 round mag This is the jb mix and epoxy grit version before duracoat And this is the 3m grit tape version Quote Share this post Link to post Share on other sites
effd27145 0 Posted March 16, 2015 Nice Work! Looks factory! Quote Share this post Link to post Share on other sites