Jump to content

Recommended Posts

Was shooting last week with my S&W M&P 22 handgun.  Ammo was Remington 22LR hollow points(from a "Bucket of Bullets" I purchased several months ago).  After approx 175 rounds downrange, when I pulled the trigger, it sort of went bang.  However, I also felt some of the products of combustion hit me in the face and smoke coming out of the rear of my slide.  Clearly something had gone wrong.  Retrieved the spent shell which is pictured below.  I immediately field stripped and inspected the gun. No apparent damage.  Shot about 30 rounds of a different brand afterwards with no issues.  Then called it a night.

Btw, good thing I was wearing my safety glasses over my prescription eyeglasses.

 

Any idea what may have caused this?  I assume bad ammo.  Or,  could it have been some sort of missfeed on the part of the gun?  Appreciate any feedback.

 

 

 

i-C5g2JL2-L.jpg

i-zZcNvv5-L.jpg

Share this post


Link to post
Share on other sites

I've had the same thing happen to me a couple of times.  Both with my 10/22 which has successfully fired tens of thousands of rounds over 30 years.  You inspected the gun.  I would not sweat it.  If I was shooting .45's and had a blow out like this I might be more concerned. 

Share this post


Link to post
Share on other sites

In a word Remington. There are few who produce worse ammo then Remington.

 

I don't believe this one bit, it clearly states "NEW AND IMPROVED!" on the bucket.

 

BucketOBullets.jpg

 

OP did say they were several months old though...may have been the "OLDER AND WORSE" type.  :laugh:

Share this post


Link to post
Share on other sites

That's what you get for trying to reload .22s!!! :nono:

 

Never had that happen to me yet but I have heard of it happening. It's not your gun, don't even know if it's bad ammo.

I think it's more like a few things going wrong at the exact same time. Could happen at anytime to anyone!

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.



  • olight.jpg

    Use Promo Code "NJGF10" for 10% Off Regular Items

  • Supporting Vendors

  • Latest Topics

  • Similar Content

    • By Ballard
      The same kit fits both the 9 and 40 frames so I can take it whichever you got it for.
    • By Isidro416
      Sold my GSG-5 22LR with fake suppressor. $300. These are a blast to shoot. Have two mags that have been converted to 10 rounds. Don't shoot it anymore and want to clear up some space on the safe. I live in Bergen county and will meet you in a dealer who you choose. You pay transfer so choose a cheap transfer dealer.




    • By Apollo7
      Anyone has Tkka T1x? How do you like it? Strongly considering it for my next purchase.
    • By Matroskin
      Need help deciding here:
      I'm torn between Ruger mark IV and SW22. Want to buy a universal gun for Bullseye and Steel Challenge, so it has to be bull barrel or similar.
      I like stainless steel Ruger and million aftermarket parts available but I don't like grip angle (22/45 fits better but it's plastic) and the fact that barrel is the firearm. So every time I would think of a new barrel it will have to be a new set permits....
      On the contrary SW22 has less aftermarket support and somewhat strange grip  - the angle is fine though. Plus its cheaper.
      Your opinions? pls?
      thanks in advance.
      P.S. Buck Mark is out - don't even bring it up :). I own Buck Mark, i like the way it shoots but the takedown process can be painful. last time I wanted to clean it i stripped the hex screw and had to go to a gunsmith . Also, little aftermarket options and harder to find parts. 
    • By Maksim
      Finally had the chance to spend a good amount of time with the gun.  At this price point, there is no reason not to get one!
       
  • Posts

    • In 50 years of living in NJ I've never experienced any attempt to inspect the interior of the home, and only one definite inspection of the exterior for an announced reassessment of all properties and that was a drive by. About 9 years of that was living in an apartment, but still, uncommon. Every place I lived had either a finished attic, basement, or both. But they were also included in the habitable square footage on the taxes when we got there. 
    • 27.00 and change in tolls to drive down the shore from Rutherford,  47.00 in tolls to go out to Long island to visit dying relatives. Now I read they are going to raise the fees in the DMV. Murphy lied just to get elected when he said that seniors will get a significant tax break with his StayNJ" program to stop us from leaving.   Keep voting for democrats...this is what you get.  Tax and spend is all they know.  Never cut anything.  This state sucks.
    • I get the added benefit that since I have a TSP rather than a true 401(k) they tax my retirement too. Yaaaay!
    • PX4 Full Size 9mm Type G. Upgrades include: - Type G Stealth/Low Pro Levers and Slide Release - Truglo Tritium Pro Sights, White Outline Front Sight - Beretta Competition Trigger Group - LTT Optimized Trigger Bar - PX4 D Spring All parts professionally installed by gunsmith. Pistol has 400rds through it. All original parts (trigger group, trigger bar, Type F levers, sights) are included in sale. Original Beretta case and all contents included in sale. 3-10rd mags (these are the original mags that came with it). Pistol is in Excellent condition, there are a couple minor smudges on the lower part of the slide near the frame which I guess is from the sight vise. If I didn't point them out you wouldn't even notice. Trigger is super sweet, especially the SA Reset. Between the gun, parts, and gunsmith labor I have about $1200 into it. $800 Sale is Cash Only.   I'm in Whippany near Morristown. I will travel within a reasonable distance to meet at your preferred FFL to do the transfer. Buyer pays transfer fees.   -----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------      
×
×
  • Create New...