Factory 870 Extension Issue.

[jermz1987 243]

I purchased a police trade in 870. I ordered a factory 870 +2 extension. When it arrived I installed it, The Issue I am having is that sometimes I can only load 5 shells. No matter how many ways I install the spring, tap the coupler, and do every trick in the book it still binds. I tried 2 different followers with the same issue. I tried using a Wilson Combat Spring and follower and it works perfectly. Only issue is the Wilson Spring is pretty short. Short in the sense that I can load 6 shells and push a 7th a little less the halfway in the tube. It cycles fine with no issues and does not bind. My question is this. Am I ok using this shorter Spring? Or will it cause issues when I go to shoot the gun? 

[ADK1113 1]

You're using 2 3/4 in shotshells right? And it should be fine. I'd say run it through a course of high brass and low brass and see if it fails to feed

 

Sent from my XT1254 using Tapatalk

 

 

[jermz1987 243]

yeah im using 2 3/4 shells. 

[Vlad G 345]

You might want to apply a small bevel where the two tubes meet. Odds are the spring or the follower are binding on that joint, so add a slight bevel to the inside edges of both tubes. This is specially important if the follower itself doesn't have a rear bevel, as a lot of the factory ones don't. 

[Pizza Bob 1,488]

This isn't an 870  Express is it?  IIRC there are two dimples on the mag tube that have to be drilled out in order for the extended mag to work correctly.

 

Adios,

 

Pizza Bob

[jermz1987 243]

No its a Police trade in model.

[SuperSixOne 4]

Are you using the plastic factory follower? Usually bright orange. That was my issue when I had the extension. I upgraded to aluminum GG&G follower and I no longer had that issue.

 

Sent from my XT1254 using Tapatalk

 

 

[JackDaWack 2,895]

No its a Police trade in model.

Just make sure the dimples aren't there.

[jermz1987 243]

No dimples. Im using the Wilson Combat Follower. I looked and it has no dimples. 

[Vlad G 345]

You mean the plastic one with the long leg behind it?

 

I never found it to work well for me. it has a pretty sever step in it at the back edge that touches the tube joints.

 

Anyway, bevel the inside of the tubes where they meet. Use some graphite lube inside the tube, and try it again.

[jermz1987 243]

Got a new spring and follower today and the issue is fixed.. Here is a pic of the shotgun by the way. Its a LEO trade in Police Magnum I purchased for 300.  The finish is pretty bad for the internals are mint and the action is like butter. Im probably going to order a new barrel without rifle sight for it. Then Maybe have it re parked. My dream is to send it in to Vang Comp to get some work done. 

 

[Vlad G 345]

Nice. Also, rifle sights are a good thing on that sort of gun. If I were you I shoot that barrel, see how it patterns, and if shoots well then refinish the barrel and maybe swap out the sights with fiber or tritium ones.

[jermz1987 243]

hmmm Sounds like a good idea. The wear gives it a little character. 

[Ray Ray 3,566]

Glad you fixed it.  now where is the Mossbergs?