vladtepes 1,060 Posted October 4, 2018 I might want to stipple a handgaurd but I am looking for the smallest possible stippling possible.. I just want to break up the flat surface not make 10in deep crevices... any advice.. Quote Share this post Link to post Share on other sites
SW9racer 262 Posted October 4, 2018 A soldering iron rated for electronics may work. It has a lower heat range and pinpoint tips. It would be slower work, but less chance for messing up Quote Share this post Link to post Share on other sites
Purple Patrick 638 Posted October 4, 2018 Wood burner tool from hobby lobby or similar Sent from my SM-G920V using Tapatalk Quote Share this post Link to post Share on other sites
Screwball 483 Posted October 4, 2018 Find an old part made of polymer, and experiment to find what works/you like. Do a few of them go get a technique down. Quote Share this post Link to post Share on other sites