tagonagy 17 Posted November 16, 2018 Not sure if this belongs in "handguns" or "gunsmithing" but here goes: My SAA cylinder won't rotate freely when the hammer is at half cock. When I pull the hammer back the bolt drops but then clicks back up at half cock. Any ideas what's wrong? Quote Share this post Link to post Share on other sites
High Exposure 5,662 Posted November 16, 2018 Inconceivable!!! Everyone knows: revolvers never malfunction! /sarcasm On a serious note, I have no idea. Hope you get it fixed though! Quote Share this post Link to post Share on other sites
fishnut 2,358 Posted November 16, 2018 4 minutes ago, High Exposure said: Impossible!!! Everyone knows: revolvers never malfunction! /sarcasm On a serious note, I have no idea. Hope you get it fixed though! Probably one of those glock made revolvers 1 Quote Share this post Link to post Share on other sites
High Exposure 5,662 Posted November 16, 2018 52 minutes ago, fishnut said: Probably one of those glock made revolvers Must have been.... damned Austrians. 1 Quote Share this post Link to post Share on other sites
Screwball 483 Posted November 16, 2018 What gun? Is it an actual SAA, or a clone of some make? Is this a new occurrence, and worked normally prior to this? Quote Share this post Link to post Share on other sites
GRIZ 3,369 Posted November 16, 2018 Did you take it apart? Quote Share this post Link to post Share on other sites
tagonagy 17 Posted November 16, 2018 2 hours ago, Screwball said: What gun? Is it an actual SAA, or a clone of some make? Is this a new occurrence, and worked normally prior to this? It's an uberti clone with a transfer bar safety system. The problem is intermitant but getting more frequent. 33 minutes ago, GRIZ said: Did you take it apart? I took it apart after the problem started and didn't see anything obviously wrong. However, I'm no gunsmith. Quote Share this post Link to post Share on other sites