Bully 749 Posted August 21, 2019 Made some time this week to get some personal projects off my plate. I love the look of a flush cut/target crown on any pistol and really think it makes Glocks look better. So, I did it. And then I did another one. Polished slide went out for coating. The black Gen4 is from a buddy’s gun. No receivers were harmed (or present) during the machining of this presentation. 3 Quote Share this post Link to post Share on other sites
Bully 749 Posted August 23, 2019 5 hours ago, eesee said: very nice Thanks. I may cut mine with a deeper crown. Time will tell. Quote Share this post Link to post Share on other sites
Shane45 807 Posted August 23, 2019 Are you using a bit or are you using a cutter with a pilot? Quote Share this post Link to post Share on other sites
Bully 749 Posted August 23, 2019 1 hour ago, Shane45 said: Are you using a bit or are you using a cutter with a pilot? I picked up a new (to me) lathe and I did them on that with a boring bar. I prefer using an exciting bar, but it's all I had 2 Quote Share this post Link to post Share on other sites
JackDaWack 2,895 Posted August 23, 2019 Good job, looks nice! Quote Share this post Link to post Share on other sites
Bully 749 Posted August 24, 2019 12 hours ago, JackDaWack said: Good job, looks nice! Thanks! Quote Share this post Link to post Share on other sites
Zeke 5,504 Posted August 24, 2019 Where’s the Rmr cut dude? Quote Share this post Link to post Share on other sites