Jump to content
Sign in to follow this  

9mm kx5

Recommended Posts

OK need a sanity check.. 

I am going to run an extended rail on a SBR..
I need to get out a couple of inches.. 

I already own a KX5 that I don't use.. 
The inside was really eroded from being on a 7.5in 5.56 AR15
I cut the cone down a bit to open up the hole.. a full 9mm casing drops freely through it now.. so the bullet should easily pass through it. if it dealt with that insane abuse of 5.56 out of a 7.5 I see no issue with it handling 9mm..

I believe that with the cone cut open.. it will have no problem sitting on the end of a 9mm SBR.. is there something I am not thinking of?

really poor quality picture taken in the dark.. but you get the idea.. 


Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...