1st.. holy shit.. proofread what you type and take the time to type something coherent, I'm having to guess what you actually intended out of your clearly gun related but still approaching word salad in the back half post there. I'm glad to help, but there's only so much to be done without a clear description of the problem.
So my best guess on translating your post into questions.
1a) You are having issues with failure to eject where some spent cases are not ejecting and remaining hooked on the extractor causing a jam when it tries to feed the next round.
or possibly
1b)You are loading up. pulling the trigger, get a bang and the gun seems to cycle, but next time you get a click, clear the round and find a fired shell with no bang to go with it. SO you are getting failure to eject, failure to feed, and reinsertion of the spent round.
2) you are having issues with the slide not staying open on an empty magazine.
Both versions of #1 can be caused by a bad ejector. On 320 based guns, make sure the ejector has not been bent up or otherwise damaged. It's this doohickey circled in red in the picture. If yours doesn't look like that in some way, you probably have a problem that is going to need to involve Sig CS.
Both versions of #1 and #2 can be caused by the gun short stroking. Possible causes of that:
a) making contact with the slide with your thumb or any other part of your hand while shooting and thus creating drag on the slide.
b) Failure to properly lube the gun. You said you cleaned it, you didn't say if you lubed it, but especially with the tighter lockup of the x-fives, lube matters.
c) Light loads and strong springs. If you are shooting cheap ass 115gr bulk plinking ammo, you should probably switch to the lighter of the two springs included with the gun.
d) A variation on a above. Your making contact with the slide release while operating the gun. The slide release mechanism would then in turn be creating drag on the slide causing short stroking if/when you push it up, and if you are pushing down, it will prevent it holding the slide open after the last round.
e) You have somehow created mechanical interference in the travel of the slide that is not permitting full travel. Like installing both recoil springs at once. I don't think this is possible and still having the gun work at all, but hey there are some impressive members of team push it harder out there. But in general check for anything mechanical that may be interfering with the full travel of the slide.
f) The frames are injection molded plastic. Check that there isn't some huge chunk of flashing or piece of sprue left in place by QC people in the dust cover area dragging on the slide in use (or anywhere else, but in general with polymer guns, that's the most likely spot for something like that).
g) If you are teacupping the gun and pushing up on the mag... fucking stop that. It's horrible form and can cause jams by pushing the magazine in and causing too much drag on the slide from the top round, causingslide lock prior to the last round being fired, etc. Depending on the gun in question. It's also possible to damage the ejector on the 320 by shoving the mag up into the gun too hard under certain circumstances. (i.e. slamming the mag in hard on a 21 round mag with aftermarket baseplates that don't prevent over insertion, but hey anything is possible if you are on team push it harder).
If you don't know what teacupping is, here's a helpful graphic: