Leaderboard
-
silverado427
Premier Member20Points7,501Posts -
Displaced Texan
Premier Member13Points6,122Posts -
Mrs. Peel
Moderators4Points2,611Posts -
Krdshrk
Administrators4Points19,096Posts
Popular Content
Showing content with the highest reputation on 11/20/2021 in all areas
-
1 pointMix of so african and hirtenberger austrian 550.00 picked up in waretown. First I will take. still have CMP ammo 30-06 290 for 192 rds with 24 clips. https://imgur.com/a/vPhcIYQ1 point
-
1 point
-
1 pointTrue that Viden's been against concealed carry (fudd perspective?), although he did come out against Sweeney in regards to 10 round magazine limit. I don't believe the two issues are different since the 2A should be across the board, no restrictions.1 point
-
1 pointOne of the first firearms I bought in NJ was at Bobs. When I heard him rail against CCW in NJ, I never went back.1 point
-
1 pointBob Viden is a long time friend of Senator Sweeney! Even though he represented us in the NRA, Viden always maintained his stance against concealed carry in NJ! He has repeatedly stated that NJ is too densely populated to allow CCW and that we would quickly become the wild west if CCW were allowed! Ever since I learned this fact, I have never given Bob a single Penney ever again. I never will!1 point
-
1 pointAll different colors. Birch, Walnut, Beech, Boyds, etc. This is a walnut that colors reddish when BLO is applied.1 point
-
1 point
-
1 pointYeah except that also applies to the non mim parts. SA had a spate of slide crack at stress risers because they had metallurgical problems. The issue isn't mim the issue is QA. I mean ruger knows their shit inside and out with casting. Ruger's issues tend to be with engineering and process on new stuff, but they largely work once a new product is sorted out. And I can't recall their casting ever being an issue.1 point
-
Muzzle devices of any kind (brakes/compensators/flash hiders) fall into the category of nice to have but not necessary. That being said, I have breaks/comps on all of my ARs. Their effectiveness is very subjective, but I seem to gain a benefit when using them as verified by shot timer and target scores.1 point
-
1 pointMIM isn't inherently bad, its a problem when it's not done right. They use MIM tool steel for trigger components even for high end ones such as giessele, and you rarely if ever hear people complain about their quality. But MIM definitely leaves the door open to poor quality parts. I have no doubts thats a MIM part, and its horrendous it would break considering its a low impact and stressed part.1 point
