Everything posted by Rifleman1
-
Survival Stuff / Bug Out Bag
DIY backfeeds are dangerous but with the correct procedure and precautions it is doable but I am not promoting doing it without an interlock. There are main panel interlocks available for less than $100 that will not let you turn on your backfeed breaker until the mains are off. You'll need an electrician to install the backfeed breakers in slots 2 & 4 on your panel that runs to your backfeed 240v inlet. http://static.schnei...0273-809-02.pdf I tried to have one installed but the electricians were so backed up at the time I skipped the interlock and backfed to my 240v dryer outlet during Sandy but the interlock is installed now. The hardest part was finding the connectors to build the cable (shelves were bare) and finding out where all the breakers fed power for a list of which breakers I wanted to feed with the generator. I turned off all the breakers, turned off the main, connected the backfeed cable, confirmed the mains were off, fired up the generator, turned on the supply breaker on the generator then turned on the individual breakers that I needed/wanted to have on. No one can fire up and connect the generator but me. I made sure the dryer outlet and line were of sufficient capacity for the generator output and added up all the amps on the circuits I wanted to energize so I would know it was below the capacity of the generators 8000 watts. I made sure that the generator was grounded to my 3 foot copper grounding rod near my meter and that the generator was grounded to the box on my dryer outlet and to the panel.
-
2nd Amendment Motorcycle Rally and Ride
Any developments in getting this ride scheduled and setup?
-
non resident VA no longer recognized in PA
I suppose with some type of support that she could and just put them in another category...
-
non resident VA no longer recognized in PA
There are 6 categories of firearms reciprocity in PA. Utah falls in Category 2. FL, VA, AZ are all in Category 1 - Category 1: States that have entered into written reciprocity agreements with Pennsylvania. (Title 18 Pa.C.S.A. § 6109(k)) Category 2: States that have statutory reciprocity under 6106(b)(15) of the Uniform Firearms Act. The following states have been granted statutory reciprocity without a formal written agreement under 6106(b)(15), based on the determination of the Attorney General that the other state has granted reciprocity to Pennsylvania license holders, and that the other state's laws governing firearms are similar. Colorado Iowa Idaho Indiana Louisiana Mississippi Montana North Dakota Utah Wisconsin http://www.attorneyg...ime.aspx?id=184
-
Ride for Pride - Fire Power for Freedom
I will be participating in a Ride for Pride on Sunday, April 28th 2013 from 8:30AM - 2:00PM and thought other forum members may also be interested. It is the 3rd Annual Ride for Pride - Fire Power for Freedom and is being sponsored by BSA Troop 54 in Lindenwold, NJ and Eckenhoff Motors. The ride begins at Eckenhoff Motorcycles in Cherry Hill and concludes on the Battleship Pier in Camden, NJ. Music, food, raffles and more, even a raffle to shoot off the 5 inch Gun. Free Battleship tours for all riders and co-riders. All makes & models are welcome. The flyer is attached. t54_2013_card_run_flyer.pdf
-
Heading south this week, anyone know where I can get ammo?
Whereabouts did you go in NC? Have any better luck? I'm headed down to Brunswick County NC shortly and will be shopping while I am there. I am also headed to the Ft. Myers, FL area and will be shopping there also.
-
BBQ Grills
I checked these out last week at the A&D show on Pier 94 in NYC. They looked great but I don't know about finding wood to fit in the grill tray to be able to cook with it. I discovered with the Viking that there is also a smoker box so you can smoke salmon and meats in the grill.
-
BBQ Grills
I'm looking at an Alfresco http://www.alfrescogrills.com/LX256DLX.html and a Viking http://www.vikingrange.com/consumer/products/product.jsp?id=prod170084.
-
What's your next Glock?
I chose to go the 10MM route with the G20SF rather than .40
-
What's your next Glock?
Looking at a G30s but I'm not a fan of subcompacts. I could always upgrade to a G21 Gen4 but then the laser would not fit it.
-
What's your next Glock?
Excellent choice.
-
Introductions
Hello and welcome to the Forums!
-
Woodland Park Range
Looks great! And only 3 miles from the office. Hell, now I can go shooting at lunch.
-
Woodland Park Range
Ant, Signed up for a tour on Tuesday. Wondering about rifle ports, caliber limits, shotgun ammo restrictions for now.
-
Pennsylvania No Longer Recognizes Florida Non-Res
But OC in a vehicle in PA requires a permit and the FL Non-resident may no longer be good for that since reciprocity is gone.
-
Pennsylvania No Longer Recognizes Florida Non-Res
I did that first and that is my source but it's easier to see the states lined up in a column rather than just a list. It helped me determine what permits would be most beneficial to get and It was helpful to only list my permits and where I was good to go based on the states that I travel to frequently. More information about other requirements for the trip planning is certainly required due diligence based on where I am going and what I will be doing. Before I travel, I review the requirements of each state affected by my trip similar to preparing my flight plan and calculating the aircraft weight & balance for the flight.
-
Pennsylvania No Longer Recognizes Florida Non-Res
Open Carry in NH in a vehicle requires a permit. This stuff can make you as confused as a newborn in a topless bar. I had to put together a spreadsheet for my permits to show which are good in which states so I can look at the state I am traveling to and see which permit is valid. CCW Coverage
-
Current CCW Turn Around Times From My Experience
A significant portion of the course addresses essential Utah gun laws that apply to a Utah concealed firearm permit holder. This includes the laws that apply in a self-defense shooting as well as carrying the firearm on a day to day basis. Self-defense situations and scenarios are covered so each student has a better understanding of when they should and should not use their firearm in self-defense. The proper self-defense mind-set is also taught to assist students in avoiding confrontations that may result in the use of their firearm for self-defense. All students leave the course with the knowledge they need to feel comfortable carrying a firearm on a daily basis to all the places they normally travel. The course allows ample time for questions to be asked so each student comes away with their individual concerns regarding concealed carry and use of deadly force addressed. Once you have successfully completed the class and have the instructor’s stamp of approval, you will have up to 12 months to submit the packet to the BCI along with their paperwork from the class for the permit application process. The BCI will conduct a background check for the applicant and if the applicant passes, it can take up to 60 days to receive the permit. GFH does all of the application preparation and fingerprints, photo, etc. and mails the completed packet for you to UT the morning after the class.
-
Current CCW Turn Around Times From My Experience
It makes sense to take the UT class and use that CCW permit to get AZ and NH, however, you are not demonstrating competence with the UT class. You are being briefed on UT law. You should take the NRA First Steps Pistol class and use that for States that require you have an NRA or other program that demonstrates competence and safety with the firearm. CT, for example, will not accept the 4 hour NRA First Steps Class. They require the 8 hour NRA Basic Pistol Class as a minimum. CT also requires that you have a CCW permit from another state and you are asked this before they will send you the application.
-
Current CCW Turn Around Times From My Experience
It depends on where you want to CCW. If your desire is PA, then FL will no longer get you PA. You would need a CCW non-resident permit from one of these states (assuming they offer non-resident permits)... AK, AR, AZ, CO, FL8, GA, IA, ID, IN, KY, LA, ME10, MI, NH, MO, MS, MT, NC, ND, OK, SD, TN, TX, UT, VA, WI, WV, WY (FL8 - FL resident Permit only. PA10 Only Honors Maine Resident Permit) to CCW in PA NH and VA via a recriprocity agreement gets you PA for now. UT via statutory recriprocity gets you PA. AZ requirements --> http://lmgtfy.com/?q=Arizona+CCW Utah requires a class by an approved UT instructor and the content is on UT laws. GFH gives you a CD with the UT laws on it at the end of their class. AZ will accept NRA classes, NJ Hunter Education classes and others listed in paragraph N here... http://www.azdps.gov...?l=13/03112.htm NH requires a copy of your CCW permit from another state. Turnaround time is running 30 days or so. It is quick if you need to CCW in PA while waiting for other permits. You can create a personal CCW map for your State licenses/permits here --> http://www.handgunla...eAMapNotice.pdf
-
New Show - Revolution
I enjoy it. It gets me to thinking... I recorded it to watch tonight while working on my tax return.
-
In NJ can you hold an intruder at gunpoint until LE arrive?
Yes you can.
-
North Carolina
There are certain items that are exempt from the tax on real & personal property in SC. http://www.sctax.org/Tax%20Information/property/prop.html
-
North Carolina
Be sure to do some local research. Some localities in NC have adopted, or are considering adopting ordinances like the city of Chapel Hill’s which restrict the open carry of handguns.
-
Newbie from Ocean...
Hello and welcome to the Forums!