nuffice

All put together and it wasn't really hard now that I did it, it might take me 2 hours to do again lol

Ya I will eventually I wanna get a muzzle brake too any suggestions?

Na its good I gotta get 2 e clips tomorrow to hold pins I don't like the cheap paperclips that I got from maa. Then god willing it will be done

The safety lever spring I couldn't find a good diagram I found one earlier that said to use dental floss to pull it down so its easier to.get the pin in the middle of the ring.

Eh its slow going I can't figure the internals out everything is drilled and painted. Can't figure it out tho

Tacticooled out yo

Pictures tonight if I finish

Got the front done tomorrow is drilling painting and pinning and adjusting the front sight block can't spend almost a g and have the whole front cockeyed

I know its off because the whole front sight block is twisted you can tell by looking at it its off like 8 degrees

No its off by alot a little I wouldn't care about

I was thinking they shot it at the side of a barn and gave it the go ahead. Other than the whole fab being crooked its fun to let 15 shots rip. Im gonna attempt the conversion when I get home from work. Since no one was able to help me lol

In soviet russia gun smack owner with a hammer

Shot it out of the box according to the paperwork it shot a moa @99 meters?

Took the gun out of the box at range 14 yesterday and put a few rounds thru it grouping was too the left. Did the same thing again same result on closer inspection noticed the front sight assembly is off to the left is there anyway to correct this?

Cause I don't have the time or the patience honestly. Plus I don't want to screw anything up.

Anybody want to do it lol? Im paying

Vlad pm me your location

Sounds like you wanna make a few dollars lol

The thing is I don't have the time to do it.

Like the title says I need someone to do the work. How much and where are you located pm me.

I figured you were an alphabet boy lol

Where the hell did u see me

Haha lmao ya that's mine

I got a 600 hp grand national I don't work on that either lol

Id rather just buy one done lmao