A-Tech

Yea links don't work for some reason. Prices are $16.99/box for 9mm

How did this go from Mods to Cops? Happens every time....

the 7 day wait is a "cool down period" like California. Permit would be needed, filled out when you purchased, then you pick up your firearm 7 days later.

No. You would no longer have an FPID card, it would be a part of your DL. P2P still separate.

I see what you did there with this response and your new avatar....I AM impressed...maybe

I keed! I keed!

I don't even like guns

I don't wear underwear

all gone. 1000/5000

Kimber pepper blaster is awesome

So much for that theory. He's been released with citations, and he wouldn't even sign those.

So....no response from jonnyrebel70....one and done? Dare I say that 5 letter word?

Don't go all the way to cabelas for primers than. You can get them much closer. I just got a box of federal small pistol this weekend for $40 in NJ. There were plenty on the shelf on Saturday. I only bought one box because that's all I needed and will probably see lower prices by the time I make it through my whole stash.

Quit dropping mags in the mud. Boom. No cleaning required.

I did find another place in PA that specializes in reloading and had almost everything I needed at extremely reasonable prices. Who and where?

Since when did mag limitations revolve around what ranges allow?? If a range only allowed 5rds, I wouldn't be going there. As a matter of fact, if a range limited capacity lower than legal limit at all, I wouldn't go there. Saying that it's "liveable" is flat out ridiculous. This law would apply to more than just range use. So if bad guy breaks in and attempts to rape and pillage and you put a few in him center mass, then his buddy comes in after him...what do you do?

Using Rainiers plated 115gr 9mm, I seat at 1.140. It's all about what works in the gun you're reloading for. Max OAL for 9mm is 1.169. Not much holding onto the bullet at that point, but still within specs. As for the seating variance, that is WAY too much. My seating depth variance is .003 -/+

What's the turn around time to receive the permits?

Tech Ops International in Phillipsburg. He had a BBQ sale on Saturday. Not sure what's left now.

I missed this, but was able to get a box of them from a LGS. He had a whole shelf of primers of different sizes over the weekend.

It's actually a good thing when considering the rifle getting old. I would rather it be harder to cycle the action, than be too easy. If you're set on using the ammo, you could try a lighter buffer. it might be enough to help.

what kind of feed problem is it? Does it get jammed against the round in the magazine? Does it not travel far enough back to to catch the next round? Does the next round jam while trying to chamber?

That was my primary tool when I smoked.

I do the same. It's one of the main reasons I got a tungsten ring. It won't scratch when I open beer bottles all night long. Yes it seriously was a considering factor.

Like I said, I don't know what it usually goes for. I just hoped on gunbot to get a general idea, and lowest I saw was .82/rd