Can anyone provide a recommendation to either a general metal fabricator or a Jeep specialist who can fabricate a roll bar for my vintage Jeep CJ2a? Prefer a Jeep specialist, but I am sure an experienced fabricator would be acceptable.

 

Thanks

I can't remember or find the shop in western Jersey (near Hope?) that did my brother-in-law's 94 Wrangler, but they did quality work.

Ah, found 'em:  https://ok4wd.com/

You might want to post over on the Quadratec board along with wranglerforum, etc.

Thank you. I did contact OK4wd. They were not interested in doing the work. I was a bit surprised.

They probably have enough work with outfitting mall crawlers for housewives these days.