Are there any members here that are an installer for a ductless heatpump system? I was looking at a Mitsubishi Mr. Slim 36,000BTU. Is it an easy install and can this be done by me?

Depends on how mechanically inclined you are. I would say yes though. The linesets are precharged.

It should'nt be to difficult for you Paul so long as you have the basic tools and an actylene torch/brazing rod-unlesss the unit comes with compression fittings?(which I doubt). The condenser does come pre-charged with enough refrigerent for 15-20' of line set. You will also need a vacuum pump,micron gauge, a set of refrigerent gauges,a pad to sit it on and an electrician to do the HI Voly disconnect outside and hi volt inside.By code the inside and outside unit have to have their own dedicated breaker. Also a slab to put it on. Send me a PM, maybe we can work something out, im looking for a new stripped lower.

It should'nt be to difficult for you Paul so long as you have the basic tools and an actylene torch/brazing rod-unlesss the unit comes with compression fittings?(which I doubt). The condenser does come pre-charged with enough refrigerent for 15-20' of line set. You will also need a vacuum pump,micron gauge, a set of refrigerent gauges,a pad to sit it on and an electrician to do the HI Voly disconnect outside and hi volt inside.By code the inside and outside unit have to have their own dedicated breaker. Also a slab to put it on. Send me a PM, maybe we can work something out, im looking for a new stripped lower.

 

Mitsubishi splits come with compression style linesets - precharged. No need for vac pump or gauges.

Contact Brisco (Shane).

.