One of the welds on my HK magazine cracked one me and opens up when under load, causing a failure to feed. Id like to not have to scrap a 60 dollar mag. Any suggestions?

Is it metal or plastic?? I would try gorrila glue on the plastic, maybe jb weld on the metal, disassemble completely apply on both sides and remove excess let dry for 72 hours clean up any left residue with sand paper or emry cloth and then try. Unleashed you got a tig welder Lmao that would work to. Make sure u clean the surfaces before you do either of these fixes

its pretty thick steel. I was debating a tig welder and cold blue over it but need to find someone with one

May wanna check out your local exhuast shop.. they may have one..... Or a machinists may know a welder. There's a chance though it will cost more to weld then what its worth....

Just wondering why tig and not mig welder?

Call H&K and tell them it's a brand new mag and it broke the second time you used it. Ask to send it in for a replacement. Worst they can say is "No".

call HK. in the mean time post a pic of the cracked mag..

Just wondering why tig and not mig welder?

 

Cause tig is appropriate for really fine work. What you see on American Choppers for instance is tig

Cause tig is appropriate for really fine work. What you see on American Choppers for instance is tig

 

+1 It's amazing what a good tig welder can do. The only problem I could see in this particular instance is if there really isn't enough material to join the two pieces.

+1 It's amazing what a good tig welder can do. The only problem I could see in this particular instance is if there really isn't enough material to join the two pieces.

 

That's a fact, actually you can see a really good Tig welder, weld 2 pint tips to one another.

 

Harry

Ah I see. my brother has a mig was gunna say if your in north jersey so by and he will give it a try

Bring it by my shop in plainfield any time 8:30-3pm m-f and I can tig weld it for you free