Skip to content
View in the app

A better way to browse. Learn more.

New Jersey Gun Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

What have you sold that you wish you didn't?

Featured Replies

Chris,

 

My cylinder throats measured a nominal .456" to .458". S&W replaced the cylinder, but since, at that time, they didn't have new tooling, they just mic'd another oversized cylinder to find one with the smallest throats (most worn reamer) - still too big, but no keyholing. Also had the forcing cone cut to 11 degrees.

 

Only the 25-5 had this problem. The 25-2 was only chambered in .45 ACP and they all shot like lasers. The first widely produced .45 Colt Model 25 was the 25-3 (and 25-4 which was the deluxe version of the 25-3), which was a commemorative and used the short .45 ACP cylinder of the 25-2 reamed to accept .45 Colt. It was too short to accept some Colt loadings, like a 250 gr SWC. The 25-5 was the first to utilize a longer cylinder - alas with oversize throats.

 

Adios,

 

Pizza Bob<----will tell you more about S&W revolvers than you EVER wanted to know

 

Hey Bob,

 

There are some guys on the S&W forum that have had experiences with oversized throats on their Model 25-2s.

 

http://smith-wessonforum.com/s-w-revolvers-1961-1980/90451-25-2-production-year-differences-accuracy.html

Hey Bob,

 

There are some guys on the S&W forum that have had experiences with oversized throats on their Model 25-2s.

 

http://smith-wessonf...s-accuracy.html

 

 

I was unaware of that. Even in that thread though, all but one of the oversize complaints are a maximum of .455" and no one complained of keyholing. Production tolerances vary, especially those dependent on reamers as they get smaller as they wear. A new chamber reamer may start at .455" and end its useful life at .451" - who knows? The 25-5's OTOH were all oversized, not because of production tolerances, but because they used the wrong spec's when designing the tooling. I would never warn anyone off of a 25-2, but I would stridently do so with a 25-5.

 

Adios,

 

Pizza Bob

When I was in the service back in 83 a Dan Wesson revolver with different barrels sizes. :banghead:

 

Oh now that is just a cardinal sin. You should be pistol whipped 10 times for this sin!

My first pistol.

S&W 5906 stainless 9mm.

 

I know, not very impressive. But it was my first handgun.

:icon_e_sad:

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.