wtf?

A little Paxil will have them up & running in no time

Throw them in a Saiga 223, it will cycle them just fine

A little Paxil will have them up & running in no time

 

 

Seem bent down a bit. Cialis might be better to straighten them out.

Chamber obstruction + too much enthusiasm on the forward assist?

More than likely rejects from an M249. I have a a few .50 cans full of 5.56 ammo like that. Some of it is ok, but most of it is junk after getting squashed by the M249's action..

 

FYI - if anyone runs across cartridges that have had the bullet set back, don't use 'em. They be dane-gu-bus!

Leave it to a butter bar!

Chamber obstruction + too much enthusiasm on the forward assist?

From my experience, the culprit is usually a bored cop (Security Forces). About a year ago I had do go out and inspect about 200,000 rds of 5.56 because the cops lost Lot integrity and they all had to be turned in. About 10% of them looked like that or worst. On top of that there were also things like 33 rds some how jammed in a 30 round mag and a pencil used to replace a round in another

That'll buff right out..

More than likely rejects from an M249. I have a a few .50 cans full of 5.56 ammo like that. Some of it is ok, but most of it is junk after getting squashed by the M249's action..

 

FYI - if anyone runs across cartridges that have had the bullet set back, don't use 'em. They be dane-gu-bus!

+1 on the M249. I had plenty of bad rounds through the SAW. There are telltale disintegrating link marks on the rounds. The orange tipped tracers are a giveaway.