Anybody have suggestions on how to mod or tweak your standard AR15 mag pouches to hold a mini 14 10 round mag?

 

I'm about to start trying stacked cardboard or my daughters old blocks at the bottom just to bump them up enough. Can't use magpuls or anything else on the end of them b/c there's not enough clearance.

 

Anybody have something that's worked for them consistently?

I had a crappy mag pouch I experimented with. I cut a block of styraphome to about the size i needed, wrapped it in cloath and placed it in the bottom of the pouch. finish by running a needle and thread through the pouch and the creation to keep everything in place. It worked until 15/30's became more available and was then disassembled.

Off the top of my head, you could do something like this:

 

 

Go to the craft store... or Home Depot now that I think of it. Buy some thick Velcro. Take the fuzzy side and sew half of the fuzzy size to the back of the ammo pouch facing down. Pull up on the fuzzy size so that the other half hangs down and acts as a flap.

 

Take the hook side and sew half to the front side of the ammo pouch facing up. Link the half of the hook side to the other half of the fuzzy side so it creates a velcro-linked barrier, or a pouch within a pouch.

 

The Velcro doesn't need to go across the entire width of the ammo pouch, just enough to prevent the magazine from falling completely through.

 

That's what I would do. Best of all, if you ever want to re-purpose the magazine pouch to an AR-15 pouch, all you have to do is disconnect the Velcro and let it hang down on the inside of the pouch.