Just got in to my FFL receivers with 6 position stocks. He cannot sell them unless they are pinned. What is the going price to have that done?

 

Thanks.

You can do it at home easily with a hammer, a drill and a roll pin but I think any gun smith would charge around $20-30 for it, maybe more

Do it yourself. Take a cordless drill with a 3/32 bit, a 3/32 by 3/4 inch long roll pin, drift punch to tap in pin and a small hammer. Position stock where you want it, drill hole trough stock and extension so hole is in the lower sqaure area of extension. Install roll pin. Stock now pinned and your done!

 

See "How to Pin a M4 collapsible stock" on youtube.

Depends on the stock, some stocks area PITA depending what position you want.

75 cents

 

Bring a cordless drill and a pop rivet gun with you . Tell him he can do them all with your tools.

Literally cost me about $20 but I already had a drill, just buy drill bits (harbor freight) less than $10 for a set, then a little punch set about $5 and a little punch hammer another $5.

 

Then just watch YouTube videos for free.

It's easy to do when it's in your possession, but if it's in the FFL's hands, and they won't transfer them to you or let you make them compliant at their store, you'll likely need to send them to another FFL that'll take care of the pinning, then transfer to you. Not sure where you're from, but I went to Mastodon up north for my pin job on an FFL transfer. I ordered a complete SR15 and needed the full neutering job so I wanted to have it shipped to a one-stop shop that could to the work and allow me to go pick it up w/o any compliance beef.

Depends on the stock, some stocks area PITA depending what position you want.

 

Yeah Sopmods come to mind....

Have him remove the stocks then put back on where ever you wish when receiver is in your possession.

That's why I ordered my lower receiver buffer tube only and added a stock on my own.