February 2, 201313 yr I decided that I would try to get rid of some end shake in my SP101 so I bought the extractor tool and .004" shims for an SP101 from Brownells. Takiing apart the SP101 and removing the extractor using the tool was a breeze. I was already to install a shim and I can not figure out where it should fit. The hole in the shim is only big enough for the "center rod pin" to fit through. I checked that I've received the correct part number from Brownells and they are the ones for a SP101. I can't find any info on how to install these and I'm hoping someone can help.
February 2, 201313 yr Demonstration on a S&W, but should be similar for a ruger. http://www.youtube.com/watch?v=xmYzAVgDBkY
February 2, 201313 yr Author sits on top of the face of the yoke, does not slide around a pin, sits on top of it. Demonstration on a S&W, but should be similar for a ruger. http://www.youtube.com/watch?v=xmYzAVgDBkY I've watched that video and I thought it would be the same but the bearings that I got have a small hole, much to small for the extractor to fit through it like the S&W video.
February 3, 201313 yr Picture would be better than words... My best guess in absense of one is that you didn't break it down suffiently to install them where they bear. http://www.brownells.com/.aspx/pid=0/sid=31/schematicsdetail/SP101
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.