I have to make a 1/16 hole in stain less magazines.. i hate when regular drill bits walk..

 

anyone know where to get a 1/16 center drill?

 

Like this? http://www.amazon.com/YG-1-Regular-Length-Uncoated-Diameter/dp/B009NNFPNC/ref=sr_1_5?ie=UTF8&qid=1371737461&sr=8-5&keywords=1%2F16+center+drill

I use a center punch and then drill. 

 

I also keep one of these in my car.  If you ever get trapped in your car and need to shatter a window, this will do it.  I used to keep it in my fire gear when I was a volunteer and used it quite often. 

I have to make a 1/16 hole in stain less magazines.. i hate when regular drill bits walk..

 

anyone know where to get a 1/16 center drill?

 

McMaster?

 

Grainger?

Like this? http://www.amazon.com/YG-1-Regular-Length-Uncoated-Diameter/dp/B009NNFPNC/ref=sr_1_5?ie=UTF8&qid=1371737461&sr=8-5&keywords=1%2F16+center+drill

 

 

Iv searched amazon for 2 hours LOL

I use a center punch and then drill. 

 

I also keep one of these in my car.  If you ever get trapped in your car and need to shatter a window, this will do it.  I used to keep it in my fire gear when I was a volunteer and used it quite often. 

ahh spring loaded..  I would be concerned about denting the mag with that as the walls are thin

A 1/16 center drill has a 3/16 body. Doesnt sound like that would work for what your up to unless the center its seldf is enough to get depth. If I needed a clean hole of that size I might just use a short end mill.

The center drill looks perfect. the Cutting tip looks like it will just make it.. I know this weekend when i test it

mscdirect.com or http://bauerfactorysupply.com/ (in north nj) i know im late to the convo lol but if you need anything for another job