I recently purchased a cheap mtech knife from an army navy store because I was feeling guilty for frequenting and not buying anything. Got it because of the wood handle.

 

Problem, aside from being more dull than a butter knife or brick, is that the screws keeping the belt clip attached, well, don't really stay in. So, know a place I can get screws around the 2mm diameter variety. I feel maybe model car screws?

 

Strange request I know.

 

And to track on another q. What do you use to sharpen?

 

Thanks for any help.

 

KCCO

Loctite

Loctite

 

This.  I've used it with a couple knives when the screws backed out. 

 

I have an arkansas stone for a sharpener

for sharpening

http://www.kmesharp.com/

Well i want to replace rather than basically glue it in. one of them actually just falls out, so I wanted to resize the hole. Sorry if I didn't explain that right. I'll probably use the loctite later too.   

Ken onion worksharp is easily the best sharpener for the money

Then you can also modify knives too!

Ken onion worksharp is easily the best sharpener for the money

Rounded tips?

 

Op, I agree with others, throw some loctite on those thread. Blue gell is my personal fav

Why do you want to re thread it? Is it stripped completely or just the wrong sizs

 

Sent from my XT1080 using Tapatalk

 

 

For screws try your local Ace Hardware. I don't know if Home Despot has them that small but Ace usually does, at least the ones around here.

 

For sharpeners, I've tried many, both electric and manual.  The two best IMO are the Razor Sharp System  and the  EdgePro. For my knives that I want to keep as perfect a bevel on as possible sharpening at home I use the EdgePro. I have the Apex version for roughly 4 years and it puts absolutely beautiful shaving-sharp edges on my knives if I want to go that far. If you want fast results obtaining a very sharp edge but whose bevel heights might not be perfectly aligned then the Razor Sharp System is great. For all of my EDC or beater knives I use it. I can get sharp edges in 1-2 minutes. These two systems are the best I've found and highly, highly recommend either one. (As always, I'm not affiliated with either)

Why do you want to re thread it? Is it stripped completely or just the wrong sizs

 

Sent from my XT1080 using Tapatalk

It was a cheap knife so I am guessing they sized the whole wrong. So, I'll need to go up in width I suppose. 

 

 

 

For screws try your local Ace Hardware. I don't know if Home Despot has them that small but Ace usually does, at least the ones around here.

 

For sharpeners, I've tried many, both electric and manual.  The two best IMO are the Razor Sharp System  and the  EdgePro. For my knives that I want to keep as perfect a bevel on as possible sharpening at home I use the EdgePro. I have the Apex version for roughly 4 years and it puts absolutely beautiful shaving-sharp edges on my knives if I want to go that far. If you want fast results obtaining a very sharp edge but whose bevel heights might not be perfectly aligned then the Razor Sharp System is great. For all of my EDC or beater knives I use it. I can get sharp edges in 1-2 minutes. These two systems are the best I've found and highly, highly recommend either one. (As always, I'm not affiliated with either)

Thanks for the suggestions. I'll take a look at ACE but first I'll have to find one near me. 

 

Right now I'm using the Lansky system which gives, IMO, a pretty sharp edge, but it not really ideal for my kitchen knives.