Fellas, I'm considering buying an AR w/ the following & need to know pls. what 'a OK in the Socialist Reoublic of New Jersey. I'm thinking the flash hider is a no-no so that would have to be replaced prior to shipping? Also, what about the multi-position butt stock? Thank you. Here's how they are standard:

 

* Sig Barrels, excellent quality

* Mil-spec Forged Uppers of top quality

* Mil-spec Forged Lowers of top quality

* multi-position butt stock

* Carbine M4 handguards

* EACH rifle will include a Performance Trigger Job!

* These are flat top, picatinny rail uppers

* Stepped M4 Contour Barrels

* M4 birdcage flash hiders

* Forward assists

* Mil-spec Bolt Carrier Group

Trade the flash hider for a brake (must be pinned or welded on), grind off the bayonet lug, pin the adjustable stock, and toss the 30 round magazines for 10's or 15's.

Ok thanks. The exact flash hider description is as follows:

- Standard rifle comes with a standard mil-spec birdcage, without muzzle relief cuts.

Check with your NJ dealer if they will do it after they take possession.

I could have all that done before it 's shipped but @ extra cost. How much I do not know yet. It's very good deal as is @ $600.00 but maybe not so much of all the work that has to be done just to make it legal here costs me a couple hundred bucks or more!?

I could have all that done before it 's shipped but @ extra cost. How much I do not know yet. It's very good deal as is @ $600.00 but maybe not so much of all the work that has to be done just to make it legal here costs me a couple hundred bucks or more!?

 

 

It depends. Since it says m4 contour barrel profile, that says to me 14.5" barrel with permanently attached muzzle device already on it. To modify that, you have to remove that, and put on a new one which is much more work than on a 16" barrel where rifles destined for free america have bits on the end that just unscrew. IF you know what you are doing, clocking it, drilling it, pinning it and welding it is maybe 20-30 minutes work plus parts.