I'm thinking about picking up this stock but don't know where to pin it. Any ideas?

 

http://www.bravocompanyusa.com/B5-Systems-Bravo-Milspec-Stock-FLAT-DARK-EARTH-p/b5(1085)system-bravo-stock-fde.htm

Normally you pin into the "side" of the rail, on this stock I would pin into the bottom of the rail.  If that's not clear I can use my mad Microsoft Paint skilz and sketch up a Gugenheim worthy piece of art to describe it.

Pin thru the side of the lever.

There are a few places on that you can pin. 1 is right at the front. into the lower part of the tube. Second would be to deactivate the lever

No, I would leave it alone and move to a free state.

Thanks guys. I was thinking of pinning it on the bottom of the lever. Do you think this would hold up? Also, is this method acceptable even though it's not pinned to the tube itself? I'm pretty sure the law only states it has to be a permanent pin, and makes no mention of it having to be pinned to the tube, but I want to make sure.

Thanks guys. I was thinking of pinning it on the bottom of the lever. Do you think this would hold up? Also, is this method acceptable even though it's not pinned to the tube itself? I'm pretty sure the law only states it has to be a permanent pin, and makes no mention of it having to be pinned to the tube, but I want to make sure.

 

I'm too lazy to look it up, but I'm not aware of any statutory language or NJSP rulings that says it has to be a permanent pin. It just says the stock can't be folding/telescoping, and the permanency of any such modification isn't mentioned. I understand the ATF has made rulings what constitutes a permanent installation of a muzzle device on a threaded barrel, but nothing about fixing stocks.

Bring it here - I'll pin it for you in 5 minutes.........................

Bring it here - I'll pin it for you in 5 minutes.........................

I might take you up on that offer. I have a buddy who does this type of work on the side, and he'd do it for me for free, but you are closer.... What would be your charge if I may ask? I do need to put in a end plate QD mount as well, so I'd need to take the tube off of the receiver.

PM sent................

just to add.. really like that stock.. I was between it and the vltor.. 

just to add.. really like that stock.. I was between it and the vltor..

 

I hope I like it too! Took me two weeks to decide which one to get.

Glad I stumbled on this thread. I have that stock and couldnt figure out how to pin it. Resorted to a fixed stock on my sr15 bc of it.

 

just to add.. really like that stock.. I was between it and the vltor.. 

 

 

Get this:

 

https://dsgarms.com/knsspade