Has anyone taken the muzzle nut off of a NJ compliant WASR? I figured it was threaded on, but I read there might be press on barrel nuts? Anyone with experience before I buy a break for this? It's a 10/63 if that matters

Found this

There's no way to really determine what your WASR's muzzle might look like; it probably depends on what the Century monkeys had laying on their desk that day. I'll avoid making general commentaries; you'll just have to inspect it and see what you get.

Answering my own question should have searched more first

 

https://www.ar15.com/archive/topic.html?b=4&f=79&t=105246

I'm 99.9% sure it will be threaded on. It was most likely tac welded if it was done during import.

Thanks I looked at mine and it has standard plunger and tac weld on bottom. I think it's threaded on, I guess only one way to be sure.

Thanks I looked at mine and it has standard plunger and tac weld on bottom. I think it's threaded on, I guess only one way to be sure.

Grind the weld off and heat up in case there is a little loctite on it. Press plunger and then use your favorite tool to unscrew it.

I accept no responsibility if you mess up your gun.

 

Sent from my iPad using Tapatalk

Thanks for advise I'll have Steve at Monmouth arms handle it and put on a brake