I'm pretty much stuck on a set of LWRC Railskins but I'm running a keymod handguard.  The LWRC units, from what I found online, are 6.25" long.  However I can only find (budget) picatinny adapters in 2, 3 & 5" lengths. I have a set of BCM panels that I am not a fan of. Looking for something wider like the Railskins.

 

 

I checked all the ones we stock and none of them exceed 5.25" in length. I'm not sure I've seen longer?

Any similar alternatives? Thanks for looking into it.

Looking at the way those rail covers are designed, you might be able to use a 5.25" section and just have the leading .5-.75" unsupported. Otherwise, you could try two smaller sections and leave a small gap between them, using the rail cover to bridge them.

You are going to add 6" of picatinny per side to a keymod panel to run rail covers?

Ran across this: http://forum.lwrci.com/viewtopic.php?t=14393

Ran across this: http://forum.lwrci.com/viewtopic.php?t=14393

 

Thanks. 

You are going to add 6" of picatinny per side to a keymod panel to run rail covers?

 

That was the idea.  My hand guard only has keymod slots on 3,6 and 9:00 surfaces so I'm looking for something wide to cover in between.  Looking at some alternatives now.

That was the idea. My hand guard only has keymod slots on 3,6 and 9:00 surfaces so I'm looking for something wide to cover in between. Looking at some alternatives now.

Have you tried the Noveske panels? Hard to get on, impossible to get off. But they cover the whole thing. Putting picatinny on a keymod to put rail covers seems like a waste. Just go with a quad rail at that point.

Have you tried the Noveske panels? Hard to get on, impossible to get off. But they cover the whole thing. Putting picatinny on a keymod to put rail covers seems like a waste. Just go with a quad rail at that point.

 

 

I love the noveske panels...