This happened a while back and I didn't put it out well, because.

Anyway, since some time has elapsed, no one will care.

Advantech sheething is VERY slippery.

 

He should have known, no offense.

Definitely not too bright. Thankfully it didn't look like he got hurt too bad. More ego than anything else.

Sent from my XT1585 using Tapatalk

Aluminum ladders suck.  If the feet were in good shape and the rubber in place it should not have moved.  Using cheap tools professionally to save money, dumb.  Lucky SOB.

Lucky!

Lucky....
I fell 20ft off a ladder onto concrete. I wasn't so lucky... Snapped my foot off and have screws holding it together. Also, nerve damage, permanent Neuropathy, etc.....

3 minutes ago, bhunted said:

Lucky....
I fell 20ft off a ladder onto concrete. I wasn't so lucky... Snapped my foot off and have screws holding it together. Also, nerve damage, permanent Neuropathy, etc.....

Pics?

15 minutes ago, Ray Ray said:

Pics?

Noooo.... why would I? Happened around 1991 - fell on the job.

A pr of rubber mitts on top could have prevented it too but for me, no feet no go. I saw this exact scene happen on a job not my crew but GC's. Guy got banged up but ok however because the ladder had no feet just the squared  frame that had rounded off from wear it gouged the shit out of a new cedar deck floor causing a big buck repair. 

Shit like that you put a 2x4 cleat  at the base of the ladder. JMHO

5 hours ago, silverado427 said:

Shit like that you put a 2x4 cleat  at the base of the ladder. JMHO

That's exactly what should have happened.  I did it myself several times after it was all framed.

6 hours ago, Malsua said:

That's exactly what should have happened.  I did it myself several times after it was all framed.

He's lucky he didn't break his neck.