Everything posted by Malsua
-
Need a new Deck
I would have done a precise job of cutting and then re-attached with dowels and glue after final inspection.
-
Need a new Deck
I have had to power wash it every few years as it gets dirty, but other than that, there's nothing really to complain about. It really doesn't have a uniform color, just sorta a mishmash of greys, greens and mauve I have not seen any mold, and fade? What does that even mean? It looks faded to begin with. Wear? No, nothing has worn. As far as it goes, I would definitely do it again as it is about as maintenance free as you can get and I've never gotten splinters from it. I know someone up thread complained about heat and I have been known to spray it down on super hot days, but it's such a non issue for me.
-
Need a new Deck
Our trex deck is at right angles and 12" on center. I can feel enough flex in it if I'm paying attention that I wouldn't be comfortable with 16" on center. In the end, you're talking 5 more joists over a 20 foot span, material cost might be an extra $125 bucks. For a 10k plus project, that strikes me as a no brainer and a trivial upgrade. The trex these days probably is better than what I have since ours is over 25 years old but it's still held up just fine.
-
Need a new Deck
Yeah, it's actually turning out great. Not only all the extra space, as we went from a 10'x12' to a 16'x22' with a 14 foot cathedral ceiling but it's well insulated now and the pipes are protected from freezing which was always a problem before. My whole point to the thread was to serve as a cautionary tale about proper flashing and water management. Do it right or it will cost you in the long run.
-
Need a new Deck
The guy that installed our Trex deck in 1992 attached the ledger board to the house's rim joist and he did not leave anywhere for the water to go. In 2002, the rim joist under the kitchen sagged and cracked off the house foundation when we had about 36 inches of snow on the deck, settling our kitchen on one side by about 5 inches. That summer, I put two pressure treated 2x10s under the old rim joist and jacked the house up. In 2017, we tore off the kitchen and rebuilt it. What was left of the original ledger board was removed a claw hammer. Poor drainage is going to cost me around 70k. That said, the kitchen is turning out great! Still not done yet, but we're working on it. You can see the rotted rim joist next to the deck towards the end of this video.
-
Gunshow loophole?
In Ohio, unlike PA, there are no rules for person to person transfers between Ohio residents. I've not lived there in 22 years so I can't speak to gun shows there these days.
-
Gunshow loophole?
I bought some guns in the early to mid 90s at gun shows. Some folks would advertise "no paperwork". Here's what would happen. You'd buy a no paperwork gun and you'd get rousted by the cops/feds before you got to your car. At least this happened the first few times. It didn't take long until you'd walk along a booth and you'd be told just who the cops were and if you made a deal with someone, you'd arrange to meet them off property. It never happened to me, but it did happen to a friend and some acquaintances. They'd hold you in the lot and run you for wants and warrants, if you came back clean they'd let you go, but they also put a note in your file and if you bought too many guns, they'd bring you in. This was early on in the Clinton admin and the ATF had a hard on to bust everyone who bought a gun without a brady check even though at the time the system was garbage and it could take weeks. I'm thinking it was early 94 and into 95.
-
Public Service Announcement: Valentine's Day in 2 Days!
I got my wife one of these... https://www.apmex.com/product/95451/roman-antoninianus-claudius-ii-gothicus-the-st-valentine-coin I figure that's the oldest thing(or one of) in my county since it was minted 1700 years ago also got her one of these. https://www.apmex.com/product/117516/1-oz-silver-colorized-round-apmex-classic-valentines-day
-
SharkBite valve question
You come off the CPVC with Pex? Then you can put copper or brass or pex valves in. You can buy the cheaper composite fittings instead of the brass ones to save a few bucks. I'm sure you can find someone with the Viega tool.
-
car video cameras
This is exactly why I went to the DOD cameras. They have HDR(High Dynamic Range) and they bump and lower the ISO as needed. The 470W+ which I bought recently also has a Circular Polarizer that allows you to cut window glare. In my case, it completely eliminates it. I've considered running a separate cam in the back window, I just haven't been motivated enough to bother.
-
Missing feet, smooth wood
That's exactly what should have happened. I did it myself several times after it was all framed.
-
Missing feet, smooth wood
This happened a while back and I didn't put it out well, because. Anyway, since some time has elapsed, no one will care. Advantech sheething is VERY slippery.
-
This semi-old house
Just to expand a little more, I like to have the connection stuffed way in the back of the box and just the pigtails sticking out. Sometimes you find a box where there's too much wire and it feels like you're pulling out a rat's nest. Also, you can use ground wire nuts that allow you to push the ground wire through the cap so you don't need to pigtail it. You cut one ground shorter than the other, slide the wire nut over the long wire leaving a 3 inches or so sticking out of the top of the wire nut, stick the short wire in the nut and twist tight. DO tighten the hell out of your wire nuts. If you nicked the bare wire it'll often break. This will teach you to strip properly :). DO tape the wire nuts DO run tape around the outside of the switch as Tbill suggested since the ground wire can move and touch a terminal when you stuff it in the box. Don't exceed the box fill if you end up doing any new electric. We just rebuilt our kitchen and some of the boxes had 3 12ga wires in them that nearly maxes out the box. It's a real pain in the ass to wire and stuff in. If you can swing the space for it, always get the biggest box that will fit. It makes your life so much easier.
-
This semi-old house
Yes, it's called a pigtail. Wire nut 3 hots, 3 neutrals, 3 grounds, run the extra to the outlet. As also mentioned, that USB outlet probably has a push in spot in the back. That said, I don't like to use those as they aren't as secure(I.e. loosen over time and create a fire hazard) as the "wrap around the nut" type connection.
-
How can I register my .45?
Exactly. I moved to NJ from Ohio and brought guns with me. Most I still have, a few I sold. I did not, nor would I ever even consider registering them. I also inherited firearms from my father and step-father, both were residents of the State of Ohio when they died.
-
Keep more of your money day!
You've got a few things working against you. 1. I don't want to sell it. 2. I don't need the money. 3. Once the offer was high enough to entice me, you could buy two from someone else. I see them on Gunbroker for under $700. That's less than I paid for it, I got mine in 2009 and I paid just over 1k,(new model, Obama scarcity, Tax, Nics), so there's another strike. At the time I bought mine, you couldn't get one for ANY price. I waited almost 2 months after I ordered.
-
Keep more of your money day!
Today is the first day of my Federal Government "Raise" or more appropriately less of the Federal Government "theft" in the form of income withholding. I'm quite pleased , Thank you DJT!
-
Do You Lease Or Buy Your Vehicles?
I buy simply because I drive 21k miles a year. I can't imagine what that lease would cost. I tend to replace at about 120k miles as the cars start to burn you on repairs after that. I may keep my current Acura a bit longer, we'll see. I've got about 3 years before I hit 120k. I buy for my wife because her car is currently 10 years old with 35k miles and has been paid off for 9 years. Half down, and paid off the remainder in about 10 months. Her last car was 16 years old when I sold it, it had 38k miles on it.
-
car video cameras
My DOD LS330W took a crap so I ended up getting a DOD LS470W+ when they were running a Black Friday special. It has a circular polarizer on it that cuts glare off the dash. It works pretty well. I would never have one that showed my face. I want plausible deniability that I might not have been driving at any particular time. I wouldn't mind a rear facing camera, like an option to have the backup cam record to something.
-
The End of the F***ing World
I know Glenn needs eye bleach. That's how I feel about watching most network TV. There's never an original thought and it's a PC BS with a laugh track. One of the most intriguing things to me was that it starts out "I think I'm a psychopath" Long about episode 5 or so "I'm definitely not a psychopath". I just felt it was a pretty off the rails exploration of kids who are trying to figure out where they fit in the world. It struck me as fairly real as I've known people like those kids and that dad and the situations they were in. The real psychopath was a bit of a left hook though. Not for everyone, that's for sure.
-
NJ arrests another one, this time from FL
That's a bridge too far! They work for me i.e. John Q. Taxpayer, if they wish to call me sir, that's their option. I'm not in the habit of saying sir to my employees. I will say that you should avoid the use of "Boss". It is a common term that inmates call Correctional Officers and can indicate to the LEO that you are a prior visitor to a correctional facility and might possibly are worthy of additional scrutiny.
-
NJ arrests another one, this time from FL
Almost every cop will tell you the following axiom: If they are planning on arresting you, nothing you say will talk them out of it. However, if they are not planning on arresting you, you can easily talk them into it. Keep your mouth shut. Don't lie but don't volunteer any information. Nothing is gained by letting them make a judgment call. Their judgement is often, arrest and let the judge figure it out.
-
The End of the F***ing World
No idea of the rating. I don't recall any nudity. There's plenty of language and a couple sexual situations. There's a murder scene that's pretty graphic.
-
The Generator Thread
Ah, the Classic is essentially the same as the old compact. It has the shorter tires, which is also somewhat of an issue for me. If I lived down in Bergen county like where I work(and you live), that machine would be plenty. I just get buried up here and more horsepower and ground clearance have been an issue. My compact 24 shoots the snow a long way, it's hard for me to imagine that this new one shoots it even further.
-
The Generator Thread
Which model did you get? I have a compact 24LE(9.5 ft/lb Motor) that I've had for 4 years now and it's just a little too weak for the snow I get up here, so I convinced myself I needed a Platinum 24 SHO with the 17ft/lb motor. The other one was ok, but 18 inch snow banks just took too long. It arrives Monday.