Skip to content
View in the app

A better way to browse. Learn more.

New Jersey Gun Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

cheap steel cased russian ammo in AR..

Featured Replies

i had 2 AR's at one point and thats all I shot . If your target shooting no ,, pinking yes . Some people say it ruins the extractor , I never had any problems

 

Seriously though, the most common "issue" I've seen (and experienced once) was the stuck-casing. In some cases the round is fired, and the steel case gets stuck in the chamber. Other times the round is hot, and gets stuck... I've never actually seen this though, so, this scenario might be a fabrication of one's imagination. The stuck case (not a hot round) in the chamber I can attest to personally.

 

In any case, the original video is pretty accurate as it would be a catastrophic malfunction, and would take your rifle out of the fight indefinitely.

I'll be following this topic, of particular interest to me is people who claim the "steel on steel" contact will damage the rifle. How does it not damage an AK?

Anycrap, I just got a 1/2 case of silver bear delivered, so I'll post a report

I've shot at a minimum 3000 rounds of Silver Bear or Golden Bear out of my AR's through the years. Never a problem. Even if it does wear the extractor out faster then brass, who cares, small cheap part that every AR owner should have a spare or two anyway. Great for plinking and general blasting.

 

I stay away from the polymer/lacquer coated stuff. AK's can eat it all day long due to the taper on the cartridge. .223 with that stuff... too close of tolerances with the less tapered shell where some lacquer or polymer build-up in the chamber will cause problems. They say the newer polymer stuff won't do it, but I still just stick with the zinc/brass plated stuff which is Silver/Golden Bear. Just my IMO.

I've ran many many cases of wolf through my ARs, I've had ONE problem which was a case without a flash hole, which resulted in a jam that required mortaring the gun. Never broke an extractor, or had a stuck case, on the other hand my chambers are 5.56 not .223 and are chrome lined which helps. It is not accurate, it is dirty, but its ok as practice ammo.

I've seen three or four guys at Central Jersey have the stuck case issue. I can attest to the fact that it does happen. As far as the true cause...i'm not sure.

worst case scenario..?

 

kaboom

I've had a stuck case with regular Wolf. After that, i have up on that brand. OTOH, i've been shooting a lot of silver bear and RUAG zinc and so far its been 100% for me.

Even if there was a chance that it would not function properly....why in the world would you chance it. The price difference between the steel cased stuff and brass is nominal.

 

What is "nominal"? From what I see the price difference is substaintial... Like $130ish for 500 55gr Silver Bear versus $170ish for 500 Lake City 55gr

I've done 3-4000 rounds of polymer Wolf (WPA, Military Classic, etc) and have had one "serious" malfunction with a stuck case that required 4-5 pulls of the charging handle before it would extract.

 

It really depends on the gun tho - I've seen a couple ARs that needed a cleaning rod or some other tool to extract a stuck case. Some guns just don't like steel cased.

 

Regarding price - the last time I bought .223 (about a year ago) I paid $200 shipped per 1000 of WPA. I've never seen brass for less than like $275 shipped... but usually closer to $300. That's a pretty significant difference to me.

$2500 AR shooting steel ammo to save $50 per 1000 rounds fired makes no sense to me....

 

AR's can range from $700 up to many thousands. It's more of what you are trying to do with it, than how much you spend on ammo. If you built a precision platform out of an AR, then you will want to use .80cent per round factory match ammo or roll your own to your specs so you can chase single holes.

 

If you build a fun-gun, and enjoy plinking plates or shooting "zombie" size targets at 150 yards, the russian zinc/brass plated steel case stuff is more then adequate to have fun with.

 

The point is, for plinking like that, why spend $40 more for brass if it does nothing for you but make you feel better that you are pampering your AR?

enough said

Not sure in what world a Ferrari is comparable to an AR... but, if you actually drove your Ferrari and it ran just as good on 87 as it did on 92, why not save a few bux? Especially if it means you get to drive more?

Don't forget the $60-$80 you can get for 1000 pieces of brass after you've fired it...

Having owned a Ferrari and numerous other exotic sports cars I would not ever that thought to put anything but super in them....

 

My point being why take an un needed chance

watch-out-we-got-a-badass-over-here-meme.png

watch-out-we-got-a-badass-over-here-meme.png

 

Jared, it's not a pissing contest. Some can't afford to consistently shoot brass-cased ammo all the time.

Ray not trying to make it one.

 

Just pointing out that there is a nominal difference in cost between the 2

 

Right, but you obviously don't have financial issues while some here do.

$2500 AR shooting steel ammo to save $50 per 1000 rounds fired makes no sense to me....

 

$900 AR shooting steel ammo to save $80-$100 per 1000 rounds makes perfect sense to me. And $100 is not "nominal" for those of us that arent fortunate enough to be driving around in a Ferrari

 

BTW who has brass cased .223 in stock for $300 per 1k?

Having owned a Ferrari

 

I call BS.

Jon and I just picked up 1000 rounds each of Aguilla for 299

 

and going back just a few weeks ago before this damn 223 shortage. I was constantly grabbing AE 223 and PMC from Cabelas for 5.79 per 20 with free shipping...

 

And I was getting wolf @ $190 per 1k not too long ago and I bought 1k of Prvi m193 for $300 shipped last month, but since we dont have time machines (well I dont, maybe you have one sitting next to your ferrari :icon_mrgreen: ) What the prices were a few weeks/months/years ago make no difference now, I see the PMC @ 6.99 per 20 now, I can still get wolf @ around $4.20-$4.40 per 20.

Pics of your Ferrari Jared, or your gonna get banned for a week.

OK, golden bear seems to be not around anymore. The last 3 1000rnd orders I've been placing are all for silver bear 62gr @$250ish per 1000. I can find Aguila 55gr brass cased for $315 here at sgammo, seems to be nearly the best you can get right now for brass. Its not even 62gr which I prefer to shoot out of my 1:7 barrels.

 

I suppose if you are going to chase/catch brass, then reload or sell it off, you may be able to re-coup that extra $50-65 premium. If you aren't IMO its wasted $$ that could be put towards more ammo.

I suppose if I could afford cars like that, I can see how $50 is "nominal". My whole point in this exercise is that it is not nominal to everyone.

Jared

 

:facepalm:

Cabella's line of Russian/Wolf steel ammo (Herders) is poly coated steel and is very inexpensive. It's 55gr and goes BANG just like other ammo.

 

It often goes on sale for $0.20 per round. For $30 you can shoot 100 rounds and decide for yourself if it works in your rifle.

I agree dont shoot that crap in your AR its bad !!

 

Save it all for me and my Mini .

Cabella's line of Russian/Wolf steel ammo (Herders) is poly coated steel and is very inexpensive. It's 55gr and goes BANG just like other ammo.

 

It often goes on sale for $0.20 per round. For $30 you can shoot 100 rounds and decide for yourself if it works in your rifle.

 

And that is the best post here

I agree dont shoot that crap in your AR its bad !!

 

Save it all for me and my Mini .

 

and watch you miss!

 

jk

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.