Skip to content
View in the app

A better way to browse. Learn more.

New Jersey Gun Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

you folks ready? hurricane season...

Featured Replies

If the transfer switch also switches the neutral, this is not an issue. 

 

99% of residential ones do not. 

 

 

 

Unbonding the ground and the neutral varies from genset to genset, and I'm sure on some it's very difficult to do without damaging something else.

 

Nope. On most it's a simple matter of removing a wire. That said, there are other options such as removing the ground from the transfer switch inlet (in the panel). 

 

 

You can't have two paths for return voltages otherwise the GFCIs will trip.  Against code I'm sure, but I'd be tempted to ground the genset outside and disconnect the ground at the inlet receptacle.  The inlet box itselt can connect to the main panel ground.  The GFCIs on the genset wouldn't work properly on a ground fault but they would still trip on a short.  This is only if you can't float the neutral on the genset.

 

Yup, that's pretty much what I said. 

  • Replies 76
  • Views 3.6k
  • Created
  • Last Reply

Top Posters In This Topic

When your gasoline runs out, your tub is empty and you have no more wood left, what's your Plan F?

Point was not about electricity, it was about thinking your contingency plans ALL THE WAY THROUGH, and testing them if possible.

 

No more wood left, that would mean that the forest is bare. I have manual saws to cut trees in case I can't use my chainsaw. I have several acres of trees that I can use and I keep 2 years of firewood out on the racks seasoning. So it would have to be a really drawn out long term total armageddon type disaster...

 

I have a well and a manual pump. But I also have a small stream on my property and in a pinch I can use that. Yes, I've tested those plans. 

 

For food I can grow stuff and hunt. Plenty of deer and other wildlife if it really got desperate. But I have a few months of food stored already that I rotate out. Cans, dry beans, rice mostly. 

 

Of course guns and ammo too but that goes without saying. 

It depends on the generator. What you are describing is called "floating neutral." Some generators already come preconfigured this way. 

Lucky we own the EU6500 generator. They are already are setup with Floating neutrals.  All newer Honda's are except the EB series.

After reading this thread, I did some web surfing. 

 

Ended up talking with a local electrician. 

 

He said I could go with a Generac generator.  He said if I got the generator and propane tank, he would do the labor for $3k. 

 

Looks like the tank would be about $1000?  A 20kw Generac is about $4k.  

 

Is $8k average for this kind of setup?   

After reading this thread, I did some web surfing. 

 

Ended up talking with a local electrician. 

 

He said I could go with a Generac generator.  He said if I got the generator and propane tank, he would do the labor for $3k. 

 

Looks like the tank would be about $1000?  A 20kw Generac is about $4k.  

 

Is $8k average for this kind of setup?   

 

Typical total cost is 2x that of the cost of the generator when someone else does it.

 

When he says labor, does he me digging the ditch for the propane lines, setting a pad, installing the transfer switch?  If so, that's a "normal" cost, not a deal.

 

I bought my 14kw generac generator off of Amazon.  I poured the pad myself, I dug the propane ditch myself, put the generator on the pad myself and added a pipe and drip leg for the gas company to connect to.

 

The install of the transfer switch and the test and setup of the generator  and connections was $550.00.  Mine is an automatic standby switch.  It took about 6 hours to do the electrics which included some conduits and such.  My genset is pretty much next to the electric service.

 

The gas company dropped the propane line in the ditch and charges me a monthly $2 for the tank.   I use propane for everything, so I don't know if they'll do that part of it for you if it's just for a standby generator.

After reading this thread, I did some web surfing. 

 

Ended up talking with a local electrician. 

 

He said I could go with a Generac generator.  He said if I got the generator and propane tank, he would do the labor for $3k. 

 

Looks like the tank would be about $1000?  A 20kw Generac is about $4k.  

 

Is $8k average for this kind of setup?   

 

Sussex rural cooperative charges about 10k to install including an onan 20kw set. Seems about right.

 

The propane tank you might be able to lease from a propane supplier but you must buy propane from them. 

  • Author

After reading this thread, I did some web surfing. 

 

Ended up talking with a local electrician. 

 

He said I could go with a Generac generator.  He said if I got the generator and propane tank, he would do the labor for $3k. 

 

Looks like the tank would be about $1000?  A 20kw Generac is about $4k.  

 

Is $8k average for this kind of setup?

Yup sounds about right. The reason why I just went with the low budget route with my interlocking switch setup ($800ish for everything installed).  We don't usually lose power much (knocking on wood).

 

I'm sure its like our firearms. Everyone has different purposes and budgets.

testing out my new setup this year and no more extension cords all over the house.  finally got to install my interlocking switch and exterior inlet.  as long as the gas stations do not run out of gas we should be ok hehe.

 

bOd2OnY.jpg

 

anyone else here preparing for some power outages?

I went with the interlock too and I'm very happy with it.  We lost power here in Pt. Pleasant for two hours  a few days ago around dinner time. it ws nice to just roll out the Generator and plug in.

  • Author

I went with the interlock too and I'm very happy with it.  We lost power here in Pt. Pleasant for two hours  a few days ago around dinner time. it ws nice to just roll out the Generator and plug in.

Nice!  That's what I'm talking about.

If you guys need water during a crisis hit up lowes or home depot. People forget they stock pallets ontop of pallets. During sandy i would go there every other day for 4 cases of water and to swap out my propane tanks. I was even able to find batteries and puck lights that i used to light my house at night. Only thing they didnt have was pumps and gas cans. I now keep 2cases of 1 liter bottles, 3 cases of the smaller bottles, 1 full case of tp... and every can can sale i stock up on soup, hash, and everything else I could heat on my gas stove. As for flash lights i keep 2 with batteries in them, have 3 more mag lights empty, 2 12pack of C cell batteries for the mag lights, 15 puck lights and a crap ton of AA batteries for them. I also have a wood burning stove.. but my father in law gave me a job site propaine indoor heater we used at night and hust ran it on the piolet. Overal im confident i would be find for about a week... if i replace my generator ill have to store gas which isnt a big deal.

Typical total cost is 2x that of the cost of the generator when someone else does it.

 

When he says labor, does he me digging the ditch for the propane lines, setting a pad, installing the transfer switch?  If so, that's a "normal" cost, not a deal.

 

I bought my 14kw generac generator off of Amazon.  I poured the pad myself, I dug the propane ditch myself, put the generator on the pad myself and added a pipe and drip leg for the gas company to connect to.

 

The install of the transfer switch and the test and setup of the generator  and connections was $550.00.  Mine is an automatic standby switch.  It took about 6 hours to do the electrics which included some conduits and such.  My genset is pretty much next to the electric service.

 

The gas company dropped the propane line in the ditch and charges me a monthly $2 for the tank.   I use propane for everything, so I don't know if they'll do that part of it for you if it's just for a standby generator.

 

I wish you were my neighbor.  :(

 

And yes, I believe the labor would include everything that you listed above.  Its not that I'm incapable of doing what you described, I just dont have the knowledge. 

 

Does the tank need to go in a ditch?

I spent about 5K for a 7Kw NG Generac + auto transfer switch + 60' of new gas line. I bought the little Genny because it was the largest one that would run off my barbeque stub during the storm. I thought we would be out for a month. She runs every Sunday morning for 15 minutes and it is a happy sound.

I spent about 5K for a 7Kw NG Generac + auto transfer switch + 60' of new gas line. I bought the little Genny because it was the largest one that would run off my barbeque stub during the storm. I thought we would be out for a month. She runs every Sunday morning for 15 minutes and it is a happy sound.

Thats not to bad.. maybe ill go that route

I wish you were my neighbor.  :(

 

And yes, I believe the labor would include everything that you listed above.  Its not that I'm incapable of doing what you described, I just dont have the knowledge. 

 

Does the tank need to go in a ditch?

 

You can do most of it yourself with some time and tools.   I don't suggest installing the transfer switch...that's what I paid $500 for.  The rest was mainly my labor.

 

 

The tank itself, mine anyway, is above ground.  They do have buried tanks, but I wasn't willing to put that kind of money in for it.

You can do most of it yourself with some time and tools.   I don't suggest installing the transfer switch...that's what I paid $500 for.  The rest was mainly my labor.

 

 

The tank itself, mine anyway, is above ground.  They do have buried tanks, but I wasn't willing to put that kind of money in for it.

 

I have a buried tank. However it is owned by Ferrellgas. It gets it out the way but now I have to get an excavator if I want to change suppliers. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.