alec.mc

that was last month yes. Come early and help setup. Short staffed and could always use more volunteers

If its not here it doesn't exist ....wait. its here now... we on!

Empty 22 cases seem to find a home between the treads of my boots all the time

Here is some of my fancy * spring loaded doo-dad * as bob calls em. USPSA Belt: DAA Race Master Holster James Austin Moonclip server 1 post NM Steel Challenge Belt: CR Speed Holster 4 post NM

PM Brisco here on the forum. He's a plumber.

I dont see why you couldnt repipe that properly with pvc. Dont use a fernco

Fine Fine Fine Nick had 82.47 I had 82.94 Though, I did have a squib and have to use Toms gun, so that's where I lost my time. yup

Luckily, you shot a little better then you can add. Cause you did well, but still cant add for your life. Nick Revolver Iron: 83.47 Alec Revolver Iron: 82.94

k frame is good fot smaller hands. The recoil of the j frame snubbies woukd probably turn her off. model 15 686 617

thank you

it's called a " t " .... use it.

im like 1/4 a CJ guy. I migrate down there for the winter when OB steel moves indoors

Just steal Nicks.

Yeh, the blade techs are pretty plain jane, but will work for everything across the board, though - idpa is the only game that limits to what sort of holster you can wear, uspsa and steel you can use just about anything. Here is the DAA race master It's a great holster, strong retention - and can be used with a variety of other guns by changing out the internal block that holds on to the trigger gaurd. CR speed : The 625 is a great gun to have, it's the best gun for USPSA and IDPA, but for steel - it's probably your not so best option, 6 shots of .45 acp isnt great for steel challenge, one miss is all you get ! I'm a pretty crappy shot, so I use an 8 shot revolver with 38 special. You might want to look into the S&W 627 series as well. -alec

Ill be at OBRPC steel match. Woot woot!

I know jerry uses a cr speed for steel challenge if you are looking for the best all purpose on the cheap go worth a blade tech. Itll be legal in uspsa idpa and steel challenge I use a DAA race master for uspsa. But they run around 200 - 250. Not legal for idpa in steel challenge I use a cr speed race Holster

If you are interested in trying fiber optics give sdm fabrication a try. Ive tried em all and like them the best

More then likely it's just because of the cheap lead ammo.... Especially if it's in the barrel. If it was excessive leading on the foward face of the cylinder and forcing cone, I'd say check your timing and lockup. The cylinder stop should engage the notch on the cylinder before the hammer falls. Pull the trigger very slowly to test out And what do you mean the gun locks up with 22 shorts? are the rounds rubbing against the frame?

What do you mean the correct length of the die? The die is to be seated as low as possible - set it as low as it'll go without hitting the shell plate. all the taper crimp is supposed to do is eliminate the bell you made to insert the bullet, you shouldnt be making a 90 degree bend on the top rim of the case.

Make sure your sizing die is as low as it will go so it'll properly size. Why 1.22 ? a 90 degree lip on the crimp? taper crimp ? that sounds excessive. Give it enough to get rid of the belling, and that it holds the bullet firmly in place.

poor man rear sight white outline. gonna give the white outline a trial to see how I like them.

See what I did there?