M1152

I’d try spoofing your old mac address as a test, you have nothing to lose. If the modem works OK with the old router and then it don’t something in the new router. Also try bLxZe suggestion and update the firmware, not that you want to do it but if you brick the new router you could always return it and tell them it was DOA

so the modem reboots but the new router is stable correct? This shouldn't matter but just for laughs try spoofing the mac address from the old router into the new router. most routers have that ability, if that don't work the new device could be bad right out of the box

I believe there was a NJGF post over the summer that was pretty much was the same question. Aim and Cheaper than Dirt don’t seem to be NJ friendly when it comes to specific hardware. I guess they just assume not ship if the laws aren’t clear, can’t say I blame them…. Threaded barrel probably flags this one...

sad to see this... COLUMBUS, N.J. -- Firefighters are battling a three alarm blaze at a farmers market in Burlington County, New Jersey. The fire is burning inside at least two buildings within the landmark Columbus Farmers Market complex, located off Route 206 in Columbus. http://6abc.com/news/3-alarm-fire-burning-at-farmers-market-in-columbus-nj/400785/ EDIT: dead link/updated link here

If you like comedy check out Trailer Park Boys...

That was excellent, I’m a frequent listener to Watercolors (the smooth jazz station) on Sirius radio. They play Botti often and he’s definitely one my favorites. Thanks for sharing.

I don’t know if this helps but this video was posted here on NJGF a while back but I can’t find the original NJGF link.. Glancing at the video again at about the 0:40 second mark he makes mention of the 922r parts and then grinds the bayonet lug so could be even be a a Jersey build.... Later in the video and I see what appears to be a US made Tapco Trigger & hammer and Tapco piston. I'm going to assume the mag is US made for three more US parts. Please post it if you do it, good luck

^ ^ ^ This Take the motorcycle safety course, I don’t think the courses were available when I started out but have heard good things about them. Get something that you are comfortable riding for a season or two just to get use to the road. Then if you need a 120 cubic inch Harley, or a 200 HP crotch rocket buy one later. Riding a motorcycle in NJ is an experience to say the least. In case you didn’t notice already too many A-holes on the road that don’t drive that good to begin with who are now preoccupied texting and feeding their faces with Wendy’s burgers so you have that to contend with. When you are driving a MC you are less visible and only half the ones that do see you will give you any courtesy or respect. Good luck

Probably falls into the fine-line or Big Can of Worms category, this kind of sums it up. "The NRA itself is tax exempt (it is nonprofit to the extent of paying no corporate taxes, but donations to it are not deductible to the donor), while some associated organizations such as the NRA CIvil Rights Defense Fund can give deductibility to the donor". (cut & pasted this from another site) Meanwhile back at msnbc medical correspondent Nancy Snyderman admits violating Ebola quarantine in New Jersey EDIT: Let me just add I see why organizations want the non-profit status. At least people know what the NRA however Miller’s organization is scam hiding behind religion.

agreed, as far as placing blame I forget where I seen first but MSNBC was blaming the NRA for Ebola it never ends… let me just add the surgeon general is a political hack

That’s pretty funny you called me out for mentioning the PA state constitution but now you cite the Texas state constitution, LOL. That’s a bridge too far IMO but kudos for trying. Let’s be realistic, if there were a battle over 2A rights between Federal and State law we would be siding with the governing body that was more inline with our stance. As far as your Texas anxiety the politicians will likely prevail on that one because it is a politically charged issue and the politicians likely feel those pastors drifted too far off the reservation. Think of it think way, it’s kind of like Bryan Miller the executive director of Heeding God's Call receiving nonprofit status to hammer away on NJ law-abiding citizens who happen to be firearms owners....

Not here to argue but take a look at the Constitution of the Commonwealth of Pennsylvania and scroll down to Section 21. I *think* that may give them another layer of protection and we will never see any legislation like here in NJ. On a side note one in another thread one of our fellow NJGF members suggested going to Tanner’s a few months back. I believe that member has posted here but to respect his privacy just going to move on. So I pull into the parking lot for the first time and see a car with an Obama and NRA bumper sticker on it, LOL. It might be a Blue state but again I think they will be OK for a while on 2A.

I purchased from Monmouth Arms and used one with a Windham Weaponry upper. I lucked out because the Anderson lower and my WW upper had the same forge markings and both fit together perfectly. YMMV

For me it somewhere in the neighborhood of was 16 weeks which was the high-end of their ETA but as you know times vary based on their work load so best to check with them. I highly doubt DA will ever have a self-install kit but if that’s what you want you could always do Bastard which their competitor. I have the Bastard as well and no complaints. I don’t want to hijack the thread but the point I was trying to make is some mods don’t play nice with other mods. I’m sure the OP could install the Tapco piston on his new S762 and it will be more forgiving than it was on my S223 but if other mods are in play anything is possible. It was a while ago when I ran into the piston issue and unfortunately I don’t remember the numbers but I did measure the length and weigh of the Tapco vs the factory piston. The specs were very close but there were minor differences in weigh & length which were clearly just enough to throw off the timing in my case. I also have the S762 and after seeing what happened to my S223 I wouldn’t even think about trying exchanging the piston.

I know this is about the S762 but if you plan on ever plan on doing a Saiga 223 with the Definitive Arms mag upgrade the Tapco piston is a NO go, it will not work with their system. I had one done last year by DA and they said while test firing they found that the "timing was off and the rifle was short stoking” so the problem was directly related to the Tapco piston. They said to prove the point they swapped out my bolt carrier with a stock bolt carrier and it performed flawlessly. DA strongly suggested I reinstall the original piston which I did upon its return and I never had any issues. It was an easy enough fix and looking back the Tapco piston was not needed for my 922r numbers, the piston was simply not worth the trouble but YMMV

Nice, If you ever mass produce them I'm sure you could unload a few here. Again nice job all the way around

Sorry, I can’t offer any advice on the cowitnessing issue but I have to say it’s very nicely done. Is that the .223 or 7.62? And with the rounds peeking out of bottom of the mag I have to ask is that your mod or is Tapco offering a special 2-sided mag for ban states? I hope you get the sights worked out to your satisfaction. Again, very nice build

He’s knows that, he’s just expressing the state of mind of ALL NJ Legal gun owners. The question to ask is when are the Trenton politicians going to quit with the smoke & mirrors politics and actually do something to benefit the working class

I had mine done in 2011 and IIRC it was only took a few weeks, I only used him once.. Edit: typo

“Prosecutor seeks time to rethink position on Shaneen Allen gun case”, that’s code for let’s see how the political winds are blowing on this because this case could ruin my career due to all the fallout if we go though with this....

Looks good. I did the Darrel Scout scope mount a while back and that was a bust. Maybe if I used a better scope it would have been better but I used a cheap Simmons scope. The best front sight upgrade for me was the fiber-optic upgrade. Anyway the Mosin's are a blast to shoot, everyone should own 1 or 5, LOL

22cal on NJ Boardwalk, yes they use to have shooting galleries on the Boardwalk.

Perhaps but not as easy as before. I’d hate to even suggest this but state should have included the picture in the FID card. I wouldn’t suggest it now because you know they wouldn’t be able to leave it at that, they would revamp the entire the system costing billions and add about 30 new regulations along with it..... On a personal note there are *some* good people left in the world and you *may* get it back. I lost my wallet twice but in the 1980’s. The first time a guy in SEARS truck stopped and picked it up and brought it to my house. I offered him the cash from the wallet and he would not take it, instead he said if I ever found someone’s wallet to do the same for them. The second time someone took the contents of the wallet, SS card, DL, Health Care Card etc. and mailed it back to me minus the cash. I guess they were a little embarrassed that they took the cash and didn't provide a return address. I didn’t care because they save me hours of torment at the DVM and SS. I not longer carry my SS nor do I did I ever keep my FID card in my wallet. I only take it out when I buy something or go to the range. Plus its laminated so it don’t fit nicely in my wallet. I hope someone will return yours but in the meantime do what you need to do.

the DL has your picture

I don't think an FFL will take just the FID card for a purchase, most will require something with a picture like your DL