Skip to content
View in the app

A better way to browse. Learn more.

New Jersey Gun Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

AlDente67

Members
  • Joined

  • Last visited

Everything posted by AlDente67

  1. It shuts off after about 5 seconds of full operation and then it tries again after 5 minutes (normal timer delay). Both current temp and set point temp remain the same.
  2. When it used to work, you would set the desired temp just like a home HVAC unit. It knows the current temp of the water and should remain condensing until that setpoint is reached. In other words, when you turn on the water pump, the heat pump unit is hard plumbed into the return line and will measure the water temp going through and compare it to the desired temp. The fan will engage, followed by the scroll compressor until that point is reached. It then cycles off immediately until it detects that the temp has fallen by a degree or so under that temperature setpoint. Gas heaters will continue to run the fan a few minutes after the burner is off in order to keep venting off the heat, but this one has no need for that and can shut off the compressor and fan at the same time. It then stays in quiet monitoring mode as long as the filter is running.
  3. I think I've posted about this before, but....maybe someone ere knows someone,etc.... I have a Jandy pool heat pump that I bought and installed about 5 years ago. Fairly top line scroll compressor. It wasn't working when I opened the pool this year. The fan was dead. I called up Jandy for local leads to servicers (it is out of warranty). They referred me to a list of NJ authorized Jandy contractors, with the largest (and closest) being a large pool store company. Called them up and we set an appointment a few days later. The day before, they call me and ask if it was a pool heater or a heat pump? I said heat pump. They said they don't touch heat pumps because they are not licensed to handle Freon. I have to call an HVAC guy. I called about 5 of them near and far, and only one would touch a pool heat pump. So he came out and found some of the circuit board modules had burned out. We agreed that I would find the parts (we knew exactly what to get), and he would come back if I needed any help. He said the freon looked a bit low, but let's fix these issues first. A quick Ebay/Amazon search later, the parts arrived with no issues. I screwed them in and fired up the unit. Fan works fine, compressor kicks in, you can feel the cold air blowing normally, then it shuts down and tries again after a few minutes. No error codes, water pressure is strong, no low freon error. I call back to have him look at it again, and now they say it was a mistake to send out the tech in the first place and that they do not touch anything "dealing with water". So now I am stuck in no man's land.
  4. I called up an outfit named Up Up and Away and a nice older lady came out with her helper to do a routine cleaning. She found some of the mortar had fallen away and told me I could just get some joint cement from HD and do it myself, which I did. I appreciated her honesty and call them every year now.
  5. Can you hook me up on the 5.56 cases? Speaking of markups, when I was young, I worked at K-Mart in the days before UPC scanning took over. My job was to walk around with one of those price sticker guns and mark every item. We used a big book that had the prices listed for every item in the store. Each item was exactly 2x the cost, except in Jewelry and Camera where each item was 4x the cost. When they closed that store (Mercer Mall), people were going crazy snatching up everything in sight because of their 30% off liquidation sale.
  6. I know a good liner replacement guy in East Windsor. He did mine last summer. Not sure about the concrete work though. PM me if you want the number.
  7. I'll just cut off your hand with a sharp knife and use that.
  8. That was taken from a car forum, not a gun forum, FWIW.
  9. Posted elsewhere: "I bought this for my wife. She has small hands and it fits her hands very nicely. It is light and has a short not too stiff throw on the upper receiver charge. The draw back there is a that it stove pipes if you limp wrist it, its a trade off on the buffer spring strength. An hour at the range and I took the limp wrist out of my wife's shooting, no issues. http://www.beretta.com/en-us/px4-storm-compact/ " Does that sound normal?
  10. And what if the range is a private one, e.g. a backyard range? Must it be some official public or membership facility? I'm guessing yes, but I thought I'd ask.
  11. Mister Lassiter may have an auto-erotic, cross-dressing, asphyxiation fetish. He can prove me wrong.
  12. I hate their circulars. Very coy on the details. As if they were trying to keep the topic buried and quiet beneath the fishing lures. Is CCI 9 worth a premium? I see case lots of 500/1000 for less than that shipped just about every day.
  13. That I'd like to see, lol. Caulk backing isn't meant for freeze/thaw. That's what screws up every driveway.
  14. Also, Fios has a battery backup. I found out during Sandy that it is designed to cut off TV first, then internet, then lastly the landline phone service. Total backup time was around 3-4 hours of use. Enough to keep your phone going in case of emergency. They used to toss that in for free with the rest of the install. Not sure if that is still the case.
  15. I just had mine repaved about a month ago. I think the cost was around $1.80 per square foot, something like that. You might find better prices. This was for a 3-inch top over existing, plus a seal coat after curing. Some serious equipment rolled up for the job, and they were done in about 2 hours. Nice job, but that's the end of topping off. The next one will be a complete tear-down, else it will stick up like a highway overpass. I tried the asphalt filler in the spiderweb cracks, followed by the Home Depot 'airport grade' sealant. Took me all day with a trowel, and I would swear a year later it looked as if I never bothered. So much for that 15 year warranty. I didn't have any depressions, just the cracking. I was told that depressions meant the underlayment was shot. So we'll see how it holds up. My neighbor had the top-off done about 5 years ago when he came across a commercial paving job nearby. They had extra asphalt and agreed to swing by and use it up. He saved about a grand that way, but stumbling on a commercial parking lot job is not something you see every day.
  16. Fios is installed wherever Verizon thinks it will be profitable. They don't cherry pick areas that have no competition. They look at the cost to run the fiber (or copper, whatever the case) down the street, more or less. And then each house needs the fiber run from street to a control panel in the house. Comcast ran cable all over the place because they locked in exclusivity agreements with each town. Eventually they'd make back the investment, and then enjoy the revenue. When those agreements expired, Verizon began to move in. Comcast sat on their butt because nobody had any other choice except Sat dishes. Now they have horribly aged infrastructure and terrible service. When Fios came to town in my area, the Comcast techs would cut the fiber to try to slow down the process, believe it or not. But it doesn't matter because most houses beat feet to switch. Unfortunately for those off the beaten path, Verizon will never come to town. It isn't worth their investment, and as was said, they are moving focus to other business. In the meantime, I get 75mb up and down internet access for $45 a month, and cable TV that never goes down, never pixilates, and if I have any issue, they actually respond. The landline is easily replaced by VoIP, or just use your cellphone. The TV can be cheap or expensive depending on how many premium channels you like to watch. I can live without HBO and the like, but lately they've been throwing that in.
  17. What is involved with converting a gen to NG? Does it require a special type of unit or is there a conversion kit from regular gas? I have a 2" active gas line that was put in for a large heater, but capped off when I switched to electric. It's in a good spot for keeping out of sight (would fool the deaf looters at least). Would be nice to have the option of hooking into the line, but also to be able to use regular gas as an alternative, but that might be asking way too much.
  18. Mark of the beast for illegally transporting fireworks across state lines. We will need to confiscate those.
  19. No that much of a big deal. Just an acquaintance who I run into in slightly different circles. The stories vary except that I'm the common listener, if you will. Would be fun to show he is full of it for sure. I just cannot stand a bullshitter. One of my pet peeves.
  20. Berretta Storm comes in 9mm, 40 and 45, for a mere $600.
  21. He lies. Says he was a sniper (he sucks) and also a tank driver. The two don't exactly jive. Has a scar on his belly. Says he was shot on active duty. Graduated from Penn State in 1992, so missed most of Dessert Storm. As far as I know, may have been enlisted in Germany for a time, but I can't think of a conflict any sniper/tanker participated in. So yes, stolen valor is part of it, but moreso some firmer evidence he is full of shit. As far as banging some Jewish chicks, I tend to doubt that.
  22. Umm, can I have your canned soup then? Awkward, I know...
  23. Note to self....Tex has a few hundred in his pocket right now... Golden Corral, here we come baby!
  24. What would you do to see if a specific person (by name and approx age/hometown) actually served in the military as claimed? I know the years/possible locations.
  25. I'll try that. What is involved in jumping out? Just cross-connect the in and out wire?

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.