Turbotezza

Ah! The infamous 1/4 semi auto pump

I do too, but sometimes it does slip your mind. It almost happened to me once while driving near the NJ border!!

Vepr 12's in post #4! Hehehehe! I can't wait!

It's already been done dude!

I'd use sgammo.com. Good prices on 9mm Gold Dot's. $26 for 50rds.

It's cool. No offence taken and thanks.

I was thinking about shooting singles on 'Full-auto" mode.

In subgun matches the idea is to have an as slow cyclic rate as possible. In the early days the MP5 were king, but then rate reduction kits were made available for the MAC type guns which allowed those to dominate.

Dude! Late again! This time by 7 months!!

I'm not gonna let you shoot up my house!! However, my neighbor has a Obama/Biden banner in the front yard.

Totally original Molot Russkie's defination of beauty. All the vendors will have the option of switching it out for a regular black Tapco, but you'd be crazy to. Remove the pistol grip, install a thumbhole stock and (IMHO) you're cherry.

Vepr 12 shotgun!! And it comes in the config. in the pic. No more conversion malarkey!! (Quoted from a vendor's website) Vepr 12 Gauge Features: Hinged dust cover with a picatinny rail Original Molot Polymer Pistol Grip Original Molot Polymer Lower Handguard Original Molot Polymer Upper Handguard Molot Self-Regulating Gas System Molot Laminate Buttstock Original Molot Competition Magazine Well One Original Molot Factory 5 round Magazine Molot Factory AK adjustable rear sight Molot Original AK enhanced safety lever, single finger operation Factory chrome lined barrel, chamber, receiver shaft and gas chamber Factory last round bolt hold open Factory threaded barrel (thread pattern is the same as Saiga) Factory machined bolt assembly, gas blocks etc. (not cast like other AK shotguns)

No really! Maybe except for the few exiles here in PA. Pre-orders going on now at 3 vendors. I got meez one!!!

There was a furry of mp5 clone builders in the early 2000's, but then HK clamped down with lawsuits. Then there were also some infighting, badmouthing, bad blood among the builders/part suppliers etc. and as a result, clone parts are harder to get. Original parts kits are just too expensive at $2-3k just for the bits. There is one now on GB, but the guy's BIN is $1900. BTW, the HK licenced ATI MKE MP5(AT94) won't accept regular MP5 mags without an modification to the inside of the mag well, so you're stuck with their stubby 10 rounders. Personally, I've been looking to replace my 9mm with a 10mm version, but those are even harder to find.

Wasn't there a company making them for like $10K-$20k a pop?

My Gauss rifle beats that slow azz plasma rifle.

Perfectly legal with a blocked magazine.

9mm. It is Special Weapons SW5 that works!

The Fastfire is for quick short range work. And yes it is up there so that I can use the irons.

You know you want one of these!!

A custom Purdy shotgun 10ga or H&H/Gibbs/Richards double rifle from the 1930's.

Plainsboro can do it in a week.

There models with the front sight on the gas block. These seem to be more rare and/or desirable as they are harder to find.

9mm Gold Dots +P back in stock at SGammo!!! I got me sum!!

- Check the gas key screws for tightness. - Try a different buffer spring - Try a lighter buffer. If you are handy, you can actually drive out the roll pin and remove the nylon end piece, then you can easily add/subtract weight. - What diameter is the gas hole in the barrel? It should be around 0.065-0.085" or so