what is good for range Brass,Metal or Aluminum jackets and what grain is best?

How is  the Remington bucket a bullets for range?

Anyone use them in 9mm?

I only use steel jacket rounds in a AK47.  The risk of jamming up anything else is not worth the cost savings.  Something to do with non-brass casings expanding from the heat and potentially damaging the weapon, whereas the AK was designed with Russian steel in mind and has more wiggle room, or so I read somewhere.

For range ammo?  Anything except reloads from unknown sources.  Steel cased stuff is fine, aluminum cased stuff is fine too.  

Ray, not a day goes by when I'm not disturbed by your avatar.

I had a bad experience with some aluminum cased .357. The cases expanded so much in the cylinder I had to use a dowel and a hammer to get them out. Didn't have to hit them to hard but no other way to remove them.

Steel and aluminum will cause premature wear. How much premature? Meh your dollar.

25 minutes ago, Zeke said:

Steel and aluminum will cause premature wear. How much premature? Meh your dollar.

Steel will. Aluminum just creates extraction issues. Aluminum is softer than brass, not even by that much, and more brittle. So it will deform easier at higher Temps, and is likely to Crack if the casing is worked too much... 

At the end of the day, anyone worrying about this issue or asking doesn't shoot enough for it to matter... 

Buy what is affordable from a reputable company..

5 minutes ago, JackDaWack said:

Steel will. Aluminum just creates extraction issues. Aluminum is softer than brass, not even by that much, and more brittle. So it will deform easier at higher Temps, and is likely to Crack if the casing is worked too much... 

At the end of the day, anyone worrying about this issue or asking doesn't shoot enough for it to matter... 

Buy what is affordable from a reputable company..

Exactly 

Exactly

The problem with steel ammo is that it's inaccurate junk. Not a problem in an SKS.  Never had a problem with 9mm blazer, but I do prefer brass. 

 

2 hours ago, AlDente67 said:

Ray, not a day goes by when I'm not disturbed by your avatar.

Man up, dad.

1 hour ago, Zeke said:

Steel and aluminum will cause premature wear. How much premature? Meh your dollar.

Not this again.  The only way steel-cased ammo will cause premature wear is if you shoot thousands and thousands of rounds of ammo through the same gun.  Aluminum?  No.

Exactly 

2 minutes ago, Zeke said:

Exactly 

Nobody is shooting thousands and thousands of rounds of steel-cased ammo through 9mm guns.  The only guns that are seeing that many?  AKs, SKSs, Makarovs and Tokarovs.  Those are doing just fine on a strict diet of steel-cased crap.

1 hour ago, Ray Ray said:

Nobody is shooting thousands and thousands of rounds of steel-cased ammo through 9mm guns.  The only guns that are seeing that many?  AKs, SKSs, Makarovs and Tokarovs.  Those are doing just fine on a strict diet of steel-cased crap.

Can you repeat the question 

1 minute ago, Zeke said:

Can you repeat the question 

Yes

It’s the weight of the projectile 

Yes

Check with the range you are planning on using.  Some ranges have restrictions on non brass cases.   

One RO told me that they get significantly less for the brass if there are any non brass cases in the mix.

Other than that, shoot what you can get.

As long as it goes bang, I’m good

46 minutes ago, PeteF said:

Check with the range you are planning on using.  Some ranges have restrictions on non brass cases.   

One RO told me that they get significantly less for the brass if thete are any non brass cases in the mix.

Other than that, shoot what you can get.

They can pick through  the brass if they want to make money off it. 

I hear that Amazon has both brass and aluminum magnets for sale now.

At least that's what Jeff Bezos says.

And we should always believe everything Jeff Bezos says, right???

Could be the weight of the projectile.

I think the 147 is heaver than the others. Kinetic energy is half the mass times the square of the velocity? Back me up on this, Zeeker. 

One half MV squared is correct.

Did you look at your neighbor's test paper, Handyman?? 

32 minutes ago, njJoniGuy said:

One half MV squared is correct.

That is indeed correct, just requires some unit conversion to get to ft-lbs, because the imperial system of measurement is stupid.

 

What weighs more, a pound of feathers or a pound of gold?

39 minutes ago, 10X said:

What weighs more, a pound of feathers or a pound of gold?

Let's see ...

The pound of gold is worth a shitload more than a pound of feathers

But I'd rather get hit with a pound of feathers than a pound of gold!

But that brings back memories of the story of the guy who ran off the road and was killed when he ran into a henway, poor guy.

28 minutes ago, njJoniGuy said:

killed when he ran into a henway, poor guy.

Nope.  Not gonna do it.  Not gonna.  Can't make me.

This thread is just plain fun to read.   Thanks! 

I and my keltec pf9 prefer cheap Remington ammo over cheap Winchester 9mm ammo.

1 hour ago, njJoniGuy said:

But that brings back memories of the story of the guy who ran off the road and was killed when he ran into a henway, poor guy.

I’ll go there...(just for shits and giggles)....What’s a ‘henway’? 
 

 

4 minutes ago, Displaced Texan said:

I’ll go there...(just for shits and giggles)....What’s a ‘henway’? 

Thanks for asking!

About 2 pounds!