PeteF

The harbor freight tumbler is fine. I got one (5 qt) 2 years ago for around $35 and it works fine. 3 hours with lizard bedding cleans 3-400 .40S7W to a nice shine. Its a little loud but it does the job. Cheyenne Mountain and Sportsman center also carry powder. You really need to know where you are going to get to Solamons. You can drive right by and not even know it. They do have good stock and prices. EH Solomons, 142 Yellow Brook Rd, Farmingdale, NJ 07727 Mon-Wed & Fri 6:30 PM to 9:00 Sun 1:00PM-4:00PM (732) 938-2189 Call to check hours before going.

I agree with he fact that the surveillance itself was just watching PUBLIC areas which is perfectly fine. I've got a problem with New York CITY police working in a OFFICIAL capacity in another state without NJ approval. If FBI did it fine, they have jurisdiction,. If NJ state or appropriate local agencies fine. NYPD way out of line crossing the bridge. I'm sure the cops, that you arrested, did something illegal in your jurisdiction so you rightly arrested them.

He's the guy that finds the odd ammunition. Joe's side kick.

Thats the "I want to play NOW" smile

DO NOT USE ON BLUED!!!!!!!!! It will remove the bluing, says it right on the bag

I think they are making them both ways. Or maybe in process of switching production to full SPP. I was looking for some 45s on one of the ammo sites. They had 2 different types of AE 45s listed for different prices for the same quantity. Looking deeper they specifically said that the cheaper (~4-5 bucks per 500) were SPP.

I hope it something like that. I hate to see them get robbed and then screwed.

Put some roofing paper under it before bolting it down. Steel on concrete will rust.

Guns from multiple owners were under the control of one person without the owners being present. Isn't that a transfer? Shouldn't COEs have been filled out for each long gun? I'm making the assumption that the pistol was the property owners. Just asking.

I was gonna say, that looked like the Globe Trotters beating up on the Washington Generals

Are these guys gonna be screwed? I doubt the place they were stolen from is an exempted place. Transfer forms in order for all the long arms?

I'm guessing reporter dropped a 0. 14,000 makes a lot more sense.

Install the metal lath used for stucco, between th plywood and cement board. its a **** to cut and sharp as hell if forced through.

http://m.youtube.com/#/watch?v=BWO-EzoIbSs 1:22

I had a casing land on my neck and STICK. That one took skin when I flicked it off. I now always wear a hooded sweatshirt at the range.

Listen to GFH radio. Story is guy had hot brass go down the back of his shirt. Dumba$$ went to clear it with his gun hand. Problem is gun was still in his hand. Shot himself in the leg. Got immediate care and when he got out of hospital, He came back to apologize to BH owners for being an a$$.

I heard on the radio, that a teacher chased him out of the school to the shooters car where cops arrested the shooter. Big Cudos to the teacher and cops.

A perfectly legal way around the whole "necessary deviation" would be to have your dad meet you at the range and take his grandchild home with him. Since he is close that shouldn't be too big of a deal. Going home have him bring child back to the range and then both head home. At a later time set up quality time with your family. Like a nice family dinner with your parents. It's stupid that a nice simple lunch with your dad can be so difficult, but like you said your kids might miss you if you're away for 5-10 yrs

NM

You can't in NJ unless you get an exemption

I'm gonna throw in Tom Selleck, as one of the good guys. He understands proper gun control

Peels off quite easily

I wound up getting a couple hundred rounds of blazer brass as a break in for a new 1911, and found they had the small primers. The flash hole size is my biggest concern. Was concerned the rounds might actually be too low pressure when using the smaller primer and smaller flash hole.

Ok, I've finally scrounged enough SPP 45 brass to make it worth doing a reloading run. The question what is the effect on my loads by going from a Large pistol primer to a SPP. Any suggestions? Or just start the load over again @ -10% and work my way up.

I've found this one works pretty good http://njgunforums.com/forum/index.php?/forum/105-hot-deal-discussions/