-
Recently Browsing 0 members
No registered users viewing this page.
-
Supporting Vendors
-
Latest Topics
-
-
Similar Content
-
By OfcrFek
Well, on June 10th I started researching and planning how to refinish and restore an old Remington 870 to its previous glory. 10 days later, I'm finally finished! Now I'm by no means a professional, and this was the first time I've ever tried to do this kind of work on a firearm, but I think it turned out ok...
I used Birchwood Casey's Cold Bluing Kit to strip all the rust and old splochy bluing off the barrel, receiver, and mag tube. Reblued it all with the same kit, doing a lot of work with some steel wool in between coats, and using my girl's shower set to the hottest it would go to rinse all the compounds off after the allotted times.
This is pre and post re-blue of the barrel:
The stock was a little more difficult. I used some stripper agents to remove the old finish on the stock set. Then used a wet rag and iron to make the more serious dents pop back out. Then I took a sanding block to remove what finish was still there, and even the stock out over all (220 grain). Afterwards, I wiped the whole stock set down with some denatured alcohol a few times to clean it, and let it air dry. After I was sure it was dry and clean, I started applying the layers of stain (I used Gunstock 231 by Miniwax). Applied 3 layers of stain over about a 16 hour period, then let it completely dry for another 16 hours. After that, I applied a spray on Clear Semi-Gloss Polyurethane sealant (3 thin coats over about 6 hours), then gave it about 20 hours to completely dry. And bam, done.
This is the overall firearm:
Yes, that is duct tape holding the receiver together in the before pictures. Lol.
A special thanks goes out to Cowboy6373, Old School, usnmars, siderman, and Hare Trigger for all their instructions and advice on how to go about doing it!
-
By CJR
I recently received a 1961 20 Gauge Browning Lightning Over/under shotgun......It's a beautiful shotgun but I want to get it re-blued and refinished.....I was wondering if anyone knows a place I could take my shotgun for theses services.....Thanks in advanced.
-
-
Posts
-
I used to have one of the old sky screen chronos, but they dont work indoors. So I recently broke down and bought the new Garmin Xero Pro. It works indoors and doesnt record the guy next port over. Buy once cry once. I have Lee Loadmasters with ALL the modifications and they work perfect. But I dont use them in full progressive mode. Once all dies are set up, I manually load a case and bullet. Add case and bullet...pull handle...one completed round. Repeat. I go slow. I am proud of the effort I put into these rounds.
-
By thunderfox · Posted
Hmm.. Closing the gun-show loophole and expanding background checks is a step towards ensuring everyone's safety, right?) -
By High Exposure · Posted
According to the report - the ATV driver was brought to the hospital with serious injury, but alive.
-
-