10X 3,297 Posted October 24, 2020 3 minutes ago, Cheflife15 said: So with this said, alot of these rounds that dont fit in the walther fit in my sp01 chamber with no issue. So, pending they pass this test in the sp01 barrel, they should be good to fire in that gun right. Assuming you aren't experiencing other quality-control issues with the ammo (squibs, overpressure signs like flattened or pierced primers, split cases) I think the ammo would be fine to shoot in the other gun. Match guns are expected to have tighter chamber tolerances, so use that ammo up in the other gun, find something else that works better in the Walther. 1 1 Quote Share this post Link to post Share on other sites
CAL. .30 M1 2,101 Posted October 24, 2020 6 minutes ago, Cheflife15 said: So with this said, alot of these rounds that dont fit in the walther fit in my sp01 chamber with no issue. So, pending they pass this test in the sp01 barrel, they should be good to fire in that gun right. I do not like the off center cant that can be seen.... Once fired the round may enter the rifling off center axis...if so, it could cause fliers and accuracy issues. 1 Quote Share this post Link to post Share on other sites
Cheflife15 455 Posted October 24, 2020 2 hours ago, 10X said: Assuming you aren't experiencing other quality-control issues with the ammo (squibs, overpressure signs like flattened or pierced primers, split cases) I think the ammo would be fine to shoot in the other gun. Match guns are expected to have tighter chamber tolerances, so use that ammo up in the other gun, find something else that works better in the Walther. Also lets say i miss one, whats the worse that could happen? A jam? Worse? Quote Share this post Link to post Share on other sites
10X 3,297 Posted October 24, 2020 Assuming it is an issue with sizing, the worst would be a jam. A new gun shouldn’t fire out-of-battery (I.e. not locked up) so a case head separation would be unlikely 1 1 Quote Share this post Link to post Share on other sites
CAL. .30 M1 2,101 Posted October 24, 2020 47 minutes ago, Cheflife15 said: Also lets say i miss one, whats the worse that could happen? A jam? Worse? Jam....ftf... loss of accuracy...agreed no kabooms 1 Quote Share this post Link to post Share on other sites
Golf battery 1,223 Posted October 25, 2020 10 hours ago, Cheflife15 said: When it comes to inspecting, in the round drops into the chamber properly, its good to go right? Theres a bunch that simply are sized wrong. Im hoping they offer to take this crap back or credit me partially. Well see. Do like Howard. Get a new gun out of it. His glock actually got f’d up from freedom reloads. Or use it in a 929. They like a little wider 9’s. Quote Share this post Link to post Share on other sites
Cheflife15 455 Posted October 25, 2020 22 minutes ago, Golf battery said: Do like Howard. Get a new gun out of it. His glock actually got f’d up from freedom reloads. Or use it in a 929. They like a little wider 9’s. I might have missed this thread Quote Share this post Link to post Share on other sites
Pizza Bob 1,488 Posted October 25, 2020 12 hours ago, Golf battery said: Do like Howard. Get a new gun out of it. His glock actually got f’d up from freedom reloads. Or use it in a 929. They like a little wider 9’s. It wasn't a Glock, it was a 1911. There was no thread because Howard (no longer on this forum - moved to a free state) signed a non-disclosure agreement. 1 2 Quote Share this post Link to post Share on other sites