Sears Roebuck bolt action .410 (Solved)

[MarkP 0]

i'm trying to get the bolt out so i can clean it up a bit, cant seem to figure it out.... does it come out or no?

 

 

 

[MattH 0]

On every bolt action I have, you release the bolt but disengaging it, and sliding it back while depressing the trigger. The bolt should slide out the back of the receiver. Be sure he gun is unloaded before attempting this.

[MarkP 0]

On every bolt action I have, you release the bolt but disengaging it, and sliding it back while depressing the trigger. The bolt should slide out the back of the receiver. Be sure he gun is unloaded before attempting this.

 

wont let me pull the trigger while the bolt is slid back

[MattH 0]

Will it allow you to pull the trigger while you slide the bolt back? I'm not familiar with this particular model so just going by what all my other bolt actions are like.

[MattH 0]

Upon searching the net it appears there is a bolt stop screw on the left side of the receiver. Removing that will allow the bolt to slide out rearward.

 

http://wiki.answers.com/Q/How_do_you_disassemble_JC_Higgins_410_model_10125

[MarkP 0]

Upon searching the net it appears there is a bolt stop screw on the left side of the receiver. Removing that will allow the bolt to slide out rearward.

 

http://wiki.answers....410_model_10125

 

 

ahhhh, have to take out the whole barrel

[MattH 0]

not sure if the screw is accesible without removing the barrel or not.

[MarkP 0]

solved, thx much

 

[MattH 0]

Glad it worked out for you.