Jackruf 7 Posted May 11, 2022 Can anyone provide a recommendation to either a general metal fabricator or a Jeep specialist who can fabricate a roll bar for my vintage Jeep CJ2a? Prefer a Jeep specialist, but I am sure an experienced fabricator would be acceptable. Thanks Quote Share this post Link to post Share on other sites
CMJeepster 2,778 Posted May 11, 2022 I can't remember or find the shop in western Jersey (near Hope?) that did my brother-in-law's 94 Wrangler, but they did quality work. Quote Share this post Link to post Share on other sites
CMJeepster 2,778 Posted May 11, 2022 Ah, found 'em: https://ok4wd.com/ You might want to post over on the Quadratec board along with wranglerforum, etc. Quote Share this post Link to post Share on other sites
Jackruf 7 Posted May 11, 2022 Thank you. I did contact OK4wd. They were not interested in doing the work. I was a bit surprised. Quote Share this post Link to post Share on other sites
CMJeepster 2,778 Posted May 11, 2022 They probably have enough work with outfitting mall crawlers for housewives these days. Quote Share this post Link to post Share on other sites