Who has a Full Size Beretta PX4 9mm & .40?

[diamondd817 828]

I am looking to find out if the 9mm and 40 use the same frames and parts. Basically, I want to see if I could slide a PX4 9mm upper on my 40 frame and make it work.

[Krdshrk 3,878]

I think it can be done.

http://berettaforum....=px4+swap+slide

 

and

http://berettaforum.net/vb/showthread.php?t=70096&highlight=px4+swap+slide

 

Looks like the price of a 9mm barrel/slide are almost as much as a gun itself though.

[diamondd817 828]

I think it can be done.

http://berettaforum....=px4+swap+slide

 

and

http://berettaforum....=px4+swap+slide

 

Looks like the price of a 9mm barrel/slide are almost as much as a gun itself though.

 

I have searched. But I have not found 100% confirmation. I know a complete 9mm upper is needed. But I need to find out if the ejector and the feed ramps are the same in the frames.

 

Yes, I also know the cost of a new upper is high, but If I could find someone who would trade 9 for a 40 upper then....

[Krdshrk 3,878]

Might want to post on the Beretta forums asking - If anyone knows - it's them.

[diamondd817 828]

Might want to post on the Beretta forums asking - If anyone knows - it's them.

 

I did more than once. Seems no one has both a 9 and 40 in there possession to confirm frame parts.

 

My next step might be to find someone with a 9mm, meet up and compare frames for myself.

[Krdshrk 3,878]

I do have a 9mm.

[diamondd817 828]

I do have a 9mm.

 

Any way you could post a good picture of your frame? Specifically the ejector on feed ramp.