Fred2 367 Posted November 7, 2013 I am looking for a 1/4-20 swivel stud to mound a bi-pod to an existing hole on the front of the rifle. I have exhausted the usual suspects, and would rather not make one, unless I had to. It should look like this Any Ideas? Quote Share this post Link to post Share on other sites
JT Custom Guns 959 Posted November 7, 2013 Like this: http://www.ebay.com/itm/Lot-of-Two-Mossberg-Shotgun-Sling-Swivel-Studs-for-barrel-/141108533089?pt=LH_DefaultDomain_0&hash=item20dab95761 Quote Share this post Link to post Share on other sites
Fred2 367 Posted November 7, 2013 Jack Thanks for the link. I think those are 10-32 (I sent a message to confirm) 10-32 seems to be the common size. i just bought a ATI kit, and that was the size for that kit. It is starting to look like 1/4-20 is a bit of an oddball. Quote Share this post Link to post Share on other sites
njJoniGuy 2,133 Posted November 7, 2013 Start with a coupler like this: http://www.boltdepot.com/Product-Details.aspx?product=12123 Drill one end out and tap it 1/4-20 Use a short piece of a 1/4-20 bolt and voila Quote Share this post Link to post Share on other sites
Fred2 367 Posted November 7, 2013 We have one on order from Armalite, it should be here in a few days Quote Share this post Link to post Share on other sites
maintenanceguy 510 Posted November 8, 2013 I don't suppose anything here http://www.mcmaster.com/#solid-rod-ends/=pa7497 would work? Quote Share this post Link to post Share on other sites
Fred2 367 Posted November 8, 2013 Those are a really good find. If a ll else fails, the fully threaded ones would be a good place to start Quote Share this post Link to post Share on other sites