nickd308 0 Posted September 28, 2010 i was curious if someone could do this for me? i dont own the tools needed to do so and would like to know if someone on here has successfully converted a wasr 10 and would like to do mine for a fee. Quote Share this post Link to post Share on other sites
tuktuk 16 Posted October 2, 2010 hey. unless one of the members offers help, ur best bet is to go to a gunsmith. wont b able to tell u which one, cause i never went to one. but im sure somebody here will direct u, based on ur location. now u have to remember, and pls guys correct me if i am wrong, that when u make ur wasr accept double stack you also have to make sure that it is 922xyz compliant. generally speakin u have to change ur trigger group, stock set, magz and prob bolt and gas piston assembly to a US made ones. that will prob cost u as much as a rifle itself, so plan it out carefully. Quote Share this post Link to post Share on other sites
junkmanted 54 Posted October 2, 2010 just go to walmart get a cheep dremil type tool i think the black and decker is 20 bucks and cut and fit . The single stack bolts have been cut to slide through the ss mag so you may have feeding problems with the double and you may not. Quote Share this post Link to post Share on other sites
tuktuk 16 Posted October 2, 2010 just go to walmart get a cheep dremil type tool i think the black and decker is 20 bucks and cut and fit . The single stack bolts have been cut to slide through the ss mag so you may have feeding problems with the double and you may not. JManted >>> but im right about the 922xyz, no ? Quote Share this post Link to post Share on other sites
junkmanted 54 Posted October 2, 2010 JManted >>> but im right about the 922xyz, no ? Yes you are He should look at the parts there may be US parts already Quote Share this post Link to post Share on other sites
nickd308 0 Posted October 4, 2010 yea it does have a some tapco guts. planned on getting a new stock set as well. Quote Share this post Link to post Share on other sites